Chery A18. Manual — part 49
8
7. Indexed list for rapid trouble shooting
7.1 Index for fault inspecting list of fault code
Diagnosis
code
Fault
description
Diagnosis content
SN of inspecting
list
Reference page
00003
Electronic
control unit
Damaged
P. 27
01276
ABS hydraulic
pump
Electromotor
cannot
operate normally
1
P.11
00283
Sensor of left
front wheel
00285
Sensor of right
front wheel
00290
Sensor of left
rear wheel
00287
Sensor of right
rear wheel
Electric and mechanical
fault
2,3,4
P.12, P. 13, P. 14
01044
ABS
coding
error
5
P.15
00668
Power terminal
30
6
P.16
01130
ABS operates
abnormally
Signal is unreasonable
7
P.17
7.2 Index for fault inspecting list of faultless code
State of fault
SN of
inspecting list
Reference
page
Turn ignition switch to “ON” (under state of burning out), ABS
warning lamp does not light
1
P18
After starting of engine, warning lamp did not extinguish
2
P19
Brake force on two sides are inhomogeneous
Brake fore is lacking
ABS operates while treading brake pedal slightly
(the vehicle is in state of resting)
ABS operates while treading brake pedal slightly
(the vehicle is in state of running)
ABS operates
abnormally
Brake pedal vibrates smartly during operation of
ABS
3
P20
Stroke of brake pedal is too long
4
P21
Too large force is needed while treading brake pedal
5
P22
No fault code output (it is unable to communicate with fault
diagnosing device)
6
P23
9
8. ABS ECU Socket
10
9. Electric wiring diagram
Note: For connection of bouncing pins, please refer to relevant electric wiring
diagram.
11
10. Fault inspecting list of fault code
1
Fault code is 01276
Possible reason
[Explanation] The fault code should be recoded if ABS ECU finds
out that engine is operating abnormally in case that vehicle running in
speed of 20km/h or above.
[Prompt] In case that connection of wiring harness between engine
and ECU gets loose, the fault code maybe occurs. It is possible to
drive engine to perform the test by using function test of hydraulic
unit of fault diagnosing device.
l
Power supply isshort
circut or earthed
l
Wiring
harness
of
electromotor gets loose
l
Electromotor
is
damaged
Note:
Electromotor should not be droved if storage battery is discharged in excess, please check if
voltage of storage battery is normal prior to perform driving test with electromotor.
It is possible to perform driving test with electromotor while vehicle is in state of resting.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст