Chery A18. Manual — part 64
3.9. Push the roller of the upper rail of the side door
up to the open size at the center, press down the side
door by hands to separate the roller from the upper
rail
3.10. Slowly push the side door to the car rear
position till the end of the rail and carefully take it
out.
Attention: After the roller is separated from the
upper rail keep the side wall moved back flatly and
the roller can not be applied by forces from other
directions during the process of the pushing in order
to avoid the parts distortion. Put the side door on a
plane and fill a layer of protective material between
the door and the touching position of the plane
4. Assembly steps
Assemble according to the inverted sequence of the disassembly
Chapter IV Disassembly, Assembly & Maintenance of the
Front & Rear Bumper
I. Disassembly, assembly & maintenance of the front bumper
1. Preparation
Tools: Socket wrench 8# , socket wrench 10#, socket wrench 19#, connecting rod, ratchet wrench,
Phillips screwdriver, ring wrench 8#, 13# , torque wrench, etc.
2. Attentions
2.1. Please put on necessary appliances for labor protection in order to avoid the accident
2.2. Avoid as much as possible scratching the lacquer surface of the bumper when disassembling
& assembling
2.3. When disassembling in the low temperature environment, the bigger force can not be used for
fear breaching the bumper.
3. Disassembly steps
3.1. Open the front compartment for the front engine by
hands
3.2. Unscrew bolts of 2 front headlamps with the socket
wrench 10# and then take them out. (See the disassembly
way of the front headlamp).
Moment: (11±1)Nm
3.3. Unscrew left & right each 2 bolts in the main beam of
the front bumper with the ring wrench 13#. Shown as the
figure:
Moment: (14±2)N·m
3.4. Disassemble 2 front wheels with the socket wrench
(See the disassembly way of the tyre).
3.5. Lift the car to a suitable height, and unscrew fixing
bolts of the left & right wheel fenders with the socket
wrench 8#
3.6. Disassemble left & right shields below the bumper with
the same way.
Assembly moment:9±0.5 Nm
3.7. Separately unscrew fixing bolts & screws of the fender
at the side of the bumper with the socket wrench 8# &
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст