Chery A series. Manual — part 92

B. Begin the disassembly process from the
interior part of the car

Dismantle the steering wheel, pull the airbag
upwards and then remove it. (See disassembly
of airbag)
1. Loosen the lock nut between the steering
wheel and the Steering-axis.

2. Remove the control and protective switch
for the steering gear lamp.

3. Overcome the restraining force of the
fastening clamps and remove the three vents of
radiator.

Remove the cover of cup bracket and then
loosen the two fastening screws at the interior
sides.

Attention:

Do not damage the clamps of the housing.
Remove the switch and cover at the two
sides of the instrument panel. Remove the
radio cover and the air condition cover.

S-19

4. Loosen two fastening screws of the cover of

the instrument panel and remove the cover.

5. Remove the instrument fastening screws on

the partition in the driving compartment and
remove the instrument panel. Dismantle the
switch and the left bottom side cover of the
steering wheel. Dismantle the left bottom
side cover of the tool case.

6. Remove the plug; loosen the right-hand-side

fastening screws of the instrument panel and
the screws located in the space at the left
bottom side of the tool box.

7. As for those cars with plastic molded

supporting frame, you need to remove the
anti-rust leather sheath of the shift lever, the
instrument panel and the fastening screws of
the car floor plates first before disassembly.

S-20

8. Remove the plug; loosen the fastening

screws in the left side of instrument panel
and the screws of the left bottom side of the
supporting frame. Loosen the fastening
screws of the control device.

9. Remove the instrument panel, separate the

cable from the clamps and dismantle the
necessary electrical components.

Assembly

Assembly is the reverse of disassembly.

Remember the tightening torque of lock nut
should be 40N.m. During disassembly and
assembly, steps must be taken to avoid
dirtying those places that are very difficult to
clean. Keeping clean in the car is very
important.

DISASSEMBLY AND ASSEMBLY OF

PACKAGE TRAY TRIM PANEL

DISASSEMBLY

Pull out the lifting stem of the rear door frame,
after that pull out the rear chassis so as to loose
it from the fastening position of the frame.

Assembly:

Assembly steps are the reverse of disassembly.

S-21

DISASSEMBLY AND ASSEMBLY OF REAR SPEAKER

Disassembly:

Remove the fastening screws at the top and bottom of the rear seat safety belt (applicable only
for the car model with safety belt). Loosen the four screws of the frame and dismantle it.

Assembly:

The assembly steps are reverse with the above and remember that the tightening for the safety
belt is 50±10N.m.

DISASSEMBLY AND ASSEMBLY OF

SHIFT LEVER

Dismantle and replace the anti-rust corrugated
leather sheath of the shift lever, remove the
fastening screws between the chassis and the
floor plate of the car, so that the corrugated
leather sheath can pass through the hole of the
chassis, after that dismantle the chassis.

DISASSEMBLY AND ASSEMBLY OF

GLOVE BOX

Disassembly:

Dismantle the fastening screws between the
glove box and the instrument panel and also
dismantle the power supply wires for
illumination lamp. Remove the glove box.

Assembly:

Assembly steps are the reverse of disassembly.

S-22