Chery A series. Manual — part 2

UNIT

UNIT

Electric current

A（ampere）

Electric power

W（watt）

Electric resistance

Ω（ohm）

Electric voltage

V（volt）

Length mm（millimeter）

kPa（kilo pascal）

Kg/cm

2

（kilogram force per square centimeter）

Negative pressure

Bar (bar)

kPa（kilo pascal）

Positive pressure

Kg/cm

2

（kg/square centimeter）

Torque N.m（Newton meter）

L（liter）

Volume

ml（milliliter）

g（gram）

Weight

Kg (kilogram)

GI-4

FUNDAMENTAL PROCEDURES

PROTECTION OF VEHICLE
·Always be sure to cover fenders, seats and floor
areas before starting work.

PREPARATION OF TOOLS AND MEASURING EQUIPMENT
·Be sure that all necessary tools and measuring
equipment are available before starting any work.







DISASSEMBLY
·If the disassembly procedure is complex,
requiring many parts to be disassembled ,all parts
should be marked in a place that will not affect
their performance or external appearance and
identified so that reassembly can be performed
easily and efficiently.




INSPECTION DURING REMOVAL, DISASSEMBLY
·When removed, each part should be carefully
inspected for malfunction, deformation, damage,
and other problems.

GI-5

ARRANGEMENT OF PARTS
·All disassembled parts should be carefully
arranged for reassembly.
·Be sure to separate or otherwise identify the parts
to be replaced from those that will be reused.




CLEANING OF PARTS
·All parts to be reused should be carefully and
thoroughly cleaned in the appropriate method.

Warning

·Using compressed air can cause dirt and
other particles to fly out causing injury to
the eyes. Wear protective eye wear
whenever using compressed air.

REASSEMBLY
·Standard values, such as torques and certain
adjustments, must be strictly observed in the
reassembly of all parts.





·If removed, these parts should replace with new ones.

— Oil seals
— Gaskets
— O-rings
— Lockwashers
— Cotter pins
— Nylon nuts

·Depending on location:

— Sealant and gaskets, or both, should be applied to specified locations. When sealant is

applied, parts should be installed before sealant hardens to prevent leakage.

— Oil should be applied to the moving components of parts.
— Specified oil or grease should be applied at the prescribed locations (such as oil seals)

before reassembly.

GI-6

ADJUSTMENT
·Use suitable gauges and/or testers when making
adjustment.

RUBBER PARTS AND TUBING
·Prevent gasoline or oil from getting on rubber
parts or tubing.

HOSE CLAMPS
·When reinstalling, position the hose clamp in the
original location on the hose and squeeze the clamp
lightly with large pliers to ensure a good fit.

VISE
·When using a vise, put protective plates in the jaws of the vise to prevent damage to parts.

GI-7