Chery B11. Manual — part 197
PDF created with pdfFactory Pro trial version
Chery B11 Service Manual Steering
II. Assembling of steering
1.The disassemble of steering is resolved as the illustration
Disassemble of the steering
2.The disassembling of steering on the vehicle
Disassemble the air cleaner
Loosen the screw bolt of transmission oil pipe on the steering
Loosen the mounting bolt of the direction device and the
universal joint
Loosen the ball-ended screw bolt of the horizontal left/right
linkage in the direction device
40198
40199
40201
40200
1-locknut 2-horizontallinkage 3-hoop 4-dust cover 5-input axle 6-oil seal 7-oil pipe
8-fixed hole of screw nut 9-case body 10-oil cavity 11-fixed stand 12- rubber block
13-hoop 14-ball pin 15-oil seal
PDF created with pdfFactory Pro trial version
Chery B11 Service Manual Steering
Disassemble the mounting bolt of the front
venting pipe and the venting manifold of engine
Loosen the mounting bolt of the front venting pipe and the
three-way catalytic converter, as well as loosen the socket of the
front oxygen sensor and then take off the venting pipe
Loosen the screw bolt for the stand of front/rear shock
absorber
Loosen the mounting bolt of the engine bracket
Loosen the mounting bolts of the left/right
Rocker arms and the sheep-horn
Loosen the three mounting bolts and a fixity nut in the steering and take the steering down
40203
40204
40205
40206
40202
PDF created with pdfFactory Pro trial version
Chery B11 Service Manual Steering
Sequence of assembling:
-Adjust the gear bar of mechanic steering and make the equal length of left and right reach (size
a=28.5mm,b=28.5mm). Presentation as Figure 2-4,measure the distance from the flange of the case to the end
surface of gear bar.
调整位置
- Adjust the steering gear.
- Twist the fixing screw nut to the end of gear bar and maintain the above value adjusted;
- Tighten up the screw nut of steering with the torque of 30Nm;
- Put the horizontal linkage into the steering arm;
-Put on dust cover on the two sides of steering
- Tighten up the screw nut in the two sides of horizontal linkage with the torque of 32Nm;
III. Disassemble and replace the steering wheel
1.Disassemble the air bag unit. Move the steering wheel/wheels to the position of straight forward. Loosen
the screw bolt and dismantle the steering wheel.
40207
40208
40209
Adjust position
PDF created with pdfFactory Pro trial version
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст