Chery B11. Manual — part 36
Maintenance and Service
145
Automatic transmission oil
level
Chery Special Service Center will check
the level when you have regular
maintenance there.
Battery
Battery does not require much care. The
level will be checked in the regular
maintenance.
The onboard battery is completely
maintenance free. Do not use battery of
other type. The current and capacity of
new battery should keep the same with the
used one or Chery’s requirements. Please
contact Chery Service Center for the
correct specification for battery.
Windshield washer system
The washers of front and rear are watered
by the same reservoir. If necessary, mix
water and windshield shampoo at 1:20.
The correct ratio is shown on the reservoir.
Please turn the cap closely after finish
adding.
Windshield wiper blade check
Slide your fingertip on the edge of the
blade to check the coarseness. Oil, silicone
and fuel might make the blade
Maintenance and Service
146
malfunctional. We recommend you clean
the blade with glass shampoo.
Wiper blade replacement
Raise the wiper arm and form it with the
blade as a right angle. Press the spring
retainer (arrows) and extract the blade,
pulling toward the wiper arm.
Tire
Precaution for your safety
When you add fuel, please check the tire
pressure after the tire is cold (including the
spare wheel). For detailed pressure, please
see “Capacity and specification”for
reference.
Comply with the correct tire pressure
when high-loaded and high-speed. If the
pressure is insufficient, it may cause
reliability reduced, rolling resistance
increase, tire abrasion accelerate, which
may create traffic accident.
If you have to drive onto the road,
maintain low speed and keep the wheel in
straight-ahead if possible. Avoid
upstanding and sharp obstacles. Brake
carefully to avoid the tire side being
scratched.
Timely check the tire surface for
Scratch, foreign objects and uneven
abrasion . Uneven abrasion may indicate
the wheel is not balanced.
Regulations limit the depth of the scratch
on the surface. When the depth reaches the
limit of 3mm, an abrasion zone will appear
on the tire, which indicates the tire must
be replaced for the reliability and security
operations are lowered.
Maintenance and Service
147
Dispose the attrited tire
according to the local ecological
regulation. Change the winter tire to
summer tire as soon as road status allows,
which can reduce fuel consumption and
lower the noise.
Wheel replacement
Unprompted tire and wheel
may create accident, which
is not within guarantee range.
Your wheel is carefully chosen to offer
best operation, comfort and security. The
above set specification of wheel and tire is
for steel or aluminum-alloy. Please contact
Chery for other material in use.
We strongly recommend you use the
original tire or those qualified to Chery’s
specification.
If you would like to install
untypical tire or wheel (e.g.
light-alloy wheel or winter tire),
please comply with relative
instruction or contact Chery Service
Center.
Notice:
The speedometer is influenced by the
wheel measure. If the diameter of the
wheel is different with the original one,
please send the vehicle to Chery Special
Service Center for adjusting the
speedometer. Otherwise, you cannot get
the correct configuration from the
speedometer.
Snow chain
Snow chain applies to all the summer and
winter tires list in the table, but only to
front wheel.
Please do not exceed a
maximum speed of 50km/h
when snow chain is used.
Extract the snow chain
immediately for the road
without snow.
Maintenance and Service
148
When the snow chain is in use, the vehicle
with anti-sliding system might be slightly
abnormal. Switching off the system will
stop it.
Avoid damaging the round cover, extract it
before install the snow chain.
Install the round cover back immediately
after extract the snow chain.
Drive Belts
Drive belt is one of the parts contained
most severe pressure. Therefore, the belt
quality must be reliable to meet the
operational needs.
Only same measure of belt is not enough
when replacing the belt. For security,
please use the original Chery belt. You can
obtain your belt from Chery Special
Service Center.
Tension check for the drive
belt
Notice:
Belt may extend after a period of usage
and the belt will get loose when the
extension reaches some level. That will
lead to malfunction and damage to the
vehicle. Therefore, check is a must after
driving of 1000km.
Check procedure
1.
Switch off the ignition and take off
the key.
2.
Press the middle part of the belt with
thumb (approx.100N) to test the
deflection.
The max deflection: 10mm.
3. If the flexibility exceeds the limit,
please go to Chery Special Service
Center for adjustment immediately.
Vehicle Wash
Do not dump the washing material with
living garbage. Please use the local
qualified waste treatment.
Only choose the wash area that
will not affect the ecological drainage
system. Clean water is the most important
factor to protect the vehicle finish .
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст