Chery B11. Manual — part 26
Driving
105
Ÿ
During vehicle inspection.
Ÿ
When exhaust system sounds
differently.
Ÿ
After physical accidents.
Some components of
engine exhausted gas and
some chemical composition of
vehicle parts,may result in
cancer,newborn baby defect or other
reproductive system harm.
Ventilation
When vehicle is parked to be idling at a
location in open air for a long time,
window should be open for at lease 2.5
centimeters. Otherwise you can turn on the
conditioning system which will allow
fresh air to come into the vehicle.
Remove the snow, leaves
or any other objects that block the
ventilation vents,in order to improve
the ventilation performance.
Adaptive Function of
Engine Control System
If the electrical cables have been
disconnected from batteries, then after
reconnecting, the vehicle runs a little
differently. This is because that the control
system is trying to adapt itself to the
engine, it can be ignored.
Engine Speed Controller
Engine speed is controlled by the engine
computer system.
Turn off the Engine
Driving
106
Release the accelerator pedal, turn the
ignition key to “Off” position after the
engine is idling.
Do not depress the
accelerator pedal before turning off
the engine.
If the vehicle has been running at high
speed for a long time, do not turn the
engine off right away. Instead, let the
engine run at a speed higher than idle
speed for 2 minutes gradually,in order to
make the engine cool gradually.
Notice:
When the engine and the ignition switch
are just turned off , the temperature is
still very high and the fan of cooling
system will continue to work for
approximate 10 minutes. Even after it
stops, high temperature might trigger it
to resume working . For this reason, you
have to be very careful when you get
close to the engine.
Braking System
Dual return circuit braking
system
Your vehicle is equipped with double-loop
braking system. If one of the loops fails to
work, the other one will take over the job.
When one of the braking
loop fails, Higher brake application
pressure is necessary, and your
vehicle travel longer before it’s
stopped. Under this condition the
systems should be checked by your
Chery Special Service Center as
soon as possible.
Brake Fluid
If brake lamps do not come on when the
parking brake is released, brake fluid level
Driving
107
is too low.
Have the brake fluid level checked
periodically.
Fill brake fluid to the
"MAX" mark in the reservoir and
have the brake system checked by
Chery center.
Brake System Operation
It’s normal for the brake system to give off
noise when it’s working. But if it always
sounds like metal attrition, the brake pads
have probably reached their minimum
thickness and need to be replaced.
If you keep feeling the vibration when
applying the brake, have your vehicle
check at Chery Special Special Center.
The new brake pads do not achieve their
full optimal surface and wear pattern until
an initial break-in period has elapsed,
press the foot brake pedal harder as
compensation under this condition. This
also apply for the newly replaced brake
pads.
Brake pads wear greatly depends on the
traffic condition and your driving style.
For vehicles that run in downtown areas,
brake pads wears faster due to frequent
starting and parking. Please follow the
“Care and Maintenance” and have your
brake discs checked and replaced by
Chery Special Service Center.
When you’re driving down slopes, shift to
lower gear to take advantage of the
engine’s own braking effect and offload
the brake system. Do not press and hold
the brake pedal unless necessary.
Wet brake discs will decrease brake
effectiveness. While driving in wed
condition, in rain or after a car wash, brake
pedal should be pressed lightly until the
attrition between brake discs and pads has
evaporated the moisture and brake
effectiveness has been fully recovered.
Note:
If your vehicle is equipped with a
airflow fender, assure the ventilation of
brake system, or it might be over
heated.
Driving
108
Brake Servo Unit
Notice:
Brake servo unit is controlled by engine
and it works only when the engine is
working. For this reason ,you should
not shut off the engine when driving
down slopes.
If for any reason the brake servo unit fails
to work, higher brake application
pressure may be necessary to compensate
for the failure of it.
Notice:
All pedals should be able to be pressed
all the way down and recover to its
original position when released.
For this reason, do not place foot mats or
any other objects near the pedals. If you
have to do so, make sure they do not move
or interfere with the operation of the
pedals.
Antilock Brake System (ABS)
ABS prevents the wheels from locking
when braking. It achieves steering control
in emergent situations and helps you to
avoid the obstacles.
When ABS works,
ABS does not work under normal
conditions, it only works when the wheels
are locking. The vibration of brake pedal
and noise indicate that the ABS is working.
This vibration and the noise are normal.
Under this condition do not release the
brake pedal.
Exploit the Full Benefits of the
ABS System
Under emergency pressing and holding the
brake pedal all the way down will trigger
the ABS and it provide steering control. If
there’s enough distance you can avoid
hitting the obstacles.
You are recommended to get familiar with
ABS but do not take unnecessary risk for
it.
Although ABS assure
shortest braking distance, brake
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст