Chery Tiggo T11 LHD. Manual — part 129
Chery International Emergency Assistance
the negative (-) cable.
After the battery is subject to
disassembly and reconnection,
the vehicle may be indicative of
some abnormal performances
during the initial stage of driving.
This is that the engine control
system is being adapted to the
engine, and you can go unheard.
The used battery contains
sulfuric acid and lead. DO
NOT discard the battery according the
requirement of general domestic
waste. Please send it to the local
waste disposal station qualified.
Engine start-up procedure
with replaced battery
The engine is connected to the battery
with the same nominal voltage (12 V)
only. Please use the jumper wire (with
the insulating clip) and the cable with
appropriate size. Please do not
remove the battery from the vehicle
electrical system.
Power-shortage
battery
Support
battery
Chery International Emergency Assistance
Connecting leads
1.
Park the vehicles appropriately to
make them not contact each
other.
2.
Make the engine stop operating.
And switch off all unnecessary
electrical equipment.
3.
Use the lead A to connect the
positive (+) terminal of the power-
shortage battery to the positive
(+) terminal of the support
battery.
4.
Connect one end of the lead B to
the negative (-) terminal of the
support battery. And then
connect the other end of the lead
B to the metal part of the engine
to be started.
DO NOT connect the
lead B to the negative (-)
terminal of the power-shortage
battery.
5.
Make sure that the jumper cable
can’t interfere with the operating
parts of the engine.
Start the engine
In order to reduce the
voltage surge when
disassembling, please switch on
the fan and the electrical heating
type rear windscreen of the
vehicle with the power-shortage
battery.
Please DO NOT light the
headlamp to substitute
the electrical heating type
windscreen. Or the surge voltage
may damage the bulb.
1.
Start up the automotive engine
carrying with the support battery
to make it operate at an
appropriate high speed.
2.
Start up the automotive engine
with the power-shortage battery.
3.
The two automotive engines shall
operate for 3 minutes before the
leads are removed.
Remove the lead wires
Remove the lead wire B(-) firstly,
Chery International Emergency Assistance
and then remove the lead wire A(+).
Breakdown trailer
Both the rear and front of the vehicle
are equipped with the trailing ring to fix
the towing rope.
You shall drive your vehicle slowly and
smoothly to avoid the jump of the
vehicle trailed when trailing. The over-
great pulling force of the towing rope
may damage the vehicle.
The ignition switch of
the vehicle trailed shall
be in the “ON” position to make
all the steering wheel, directional
signal lamp and brake light work
while trailing. There are no the
braking-assisted force and the
steering-assisted force because
the engine is switched off. So,
the required operating physical
force shall be strengthened, and,
as a result, the corresponding
force of braking and steering
shall be added. If it is a four-
drive trailer, its wheels can’t
leave the ground and must touch
the ground, or else it will
damage the ITMI.
Chery International Emergency Assistance
Maintenance and
Service
Maintenance and service falls into two
categories. One is regular and can be
done by the owner, and the other is
regular inspection and shall be done
by Chery Authorized Service Station.
Service Offered by Chery
To maintain the reliability and
drivability of the vehicle, please
comply with regular maintenance
schedule specified in “Maintenance
Manual”. Service always provided by
Chery Authorized Service Station is
preferred.
Items you must follow
Regularly check fluid level and refill oil.
Check the tire pressure, lamps and
braking system. Then check warning
lamps. And a regular maintenance
schedule is also provided for your
reference.
The container of braking fluid, coolant
and power steering fluid is semi-
transparent for a straight and instant
check.
The electronic ignition
system has high voltage.
Please do not touch these parts
when the engine is running or
ignition switch is on.
Cut off the ignition switch
before working in the
engine compartment. Even if the
ignition switch is off, the cooling fan
may be running automatically.
Please watch your clothes (tie) to
prevent from being caught by the
fan or driving belt.
General Maintenance for a
Vehicle
When you clean the engine, the
residue of fuel, grease and engine oil
will be cleaned as well.
Only clean your car at the
washing area that does not
damage the ecological
drainage system.
Always ask for qualified waste
treatment agencies or consult
your dealer to replace and
dispose used engine oil, brake fluid,
anti-freeze fluid, battery and tire. And it
is prohibited to dump into daily rubbish
or drain it into public drainage system.
Everyone shall concern about
environment. Please offer your
contribution and shoulder your
responsibility to environmental
protection.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст