Chery Tiggo T11 LHD. Manual — part 124
Chery International Driving
Emergency
Assistance
Hazard flashlight
The hazard flashlight is applied only
under the emergency condition to
warn the coming and following
vehicles that your vehicle goes wrong
or the approach to your vehicle is
dangerous.
Press the switch to turn on or off the
flashlight. The hazard flashlight can
still operate when the ignition switch is
turned off.
Local operation function
The control system of the vehicle’s
engine has the local operation
function. The engine can still operate
when the system fails. However, the
performance of the engine may
decline.
Please get to the Chery
Authorized
Service
Station immediately to make the
engine examined.
Refill fuel in time
If the fuel gauge has
already indicated that the fuel
level is low or the warning lamp
lights, please refill fuel
immediately.
When the fuel reach the extremely low
level, the engine will operate
unsteadily acting as the additional
warning within the stretch of time after
the warning lamp for low fuel level
lights. Please get to the nearest
fueling station to refill fuel.
The failure to refill fuel in
time will be able to make
the engine turn off automatically
and result the poor start of
engine. In this case, the
emergency
assistance
conducted by the Chery
Chery International Driving
Authorized Service Station is
required. In addition, it may
make the engine damaged.
Please take care to use the
compressor gun while fueling.
The compressor gun shall be fully
inserted into the fuel tank. Do not
tilt the gun against the refill
opening.
If the automatic compressor gun
is applied, it indicates that the fuel
tank is filled up once the
compressor
gun
closes
automatically when fueling. In this
case, be sure not to try to refill
fuel continuously, or there is no
expansion space inside the fuel
tank. The fuel will spill over from
the fuel tank once the
temperature rises.
Please take care to screw up the
tank cap after fueling.
Please take care to abide by the
local related laws and regulations
when you carry the spare canned
fuel with your vehicle.
For the sake of security, it is
recommended that you don’t
carry the spare canned fuel with
your vehicle in order to avoid that
the fuel tank is damaged and the
fuel spills over to result a fire
disaster when a traffic accident
occurs.
Replace the lamp bulb
Please be sure to switch off the
lamp/light and disconnect the ignition
switch before any bulb is replaced.
Do not use your fingers to hold the
lamp glass directly, or else the
fingerprint residues on it will be heated
and volatilized after the lamp lights,
which may deposit on the mirror
surface and, as a consequence, it
make the reflector darken.
Be sure to use the same model of bulb
when replacing the bulb. Please check
the specification of the bulb before
installation.
It is recommended that you shall carry
a box of spare bulbs with your vehicle
Chery International Driving
for the emergency use. There are
various bulbs in stock in the Chery
Authorized Service Station. For the
sake of security, the following bulbs
which have significant effect on the
traffic safety shall be at least carried
with your vehicle:
Headlamp and front fog light bulbs:
12V 55W
Directional signal lamp, rear fog
light, backup light and brake light
bulbs:
12V 21W
License plate, brake, position, side
directional signal light bulbs:
12V 5W
Front/rear ceiling light bulbs:
12V 10W
The headlamp shall be
aligned after the headlamp
bulb is replaced every time.
Headlamp
assembly
(including high beam/dipped
beam/position/directional
signal lights)
The headlamp assembly shall be
removed in order to remove any
bulb above.
。
1.
Open the engine hood.
2.
Remove the three bolts used to
fix the headlamp assembly (its
positions are shown in the figure
below).
3.
Pull out the headlamp assembly
carefully and disconnect the
cable joint.
High beam/dipped beam bulbs
1.
Press the lock catch of protective
cover and remove the protective
cover of dipped beam of the
headlamp, shown as the figure
below.
Chery International Driving
2.
Pull out the plug-in parts of a
lamp receptacle, switch out and
remove the fixing clip to draw out
the bulb, and then replace the
disable bulb with a new bulb.
Fasten the fixing clip tightly, and
put on the headlamp cover.
3.
Use the headlamp beam tester to
align the light ray of headlamp.
Caution:
The halogen bulb shall be fixed in
the lamp receptacle.
Front directional signal light
bulb
1.
Grasp the lamp receptacle by
your hand and turn it
counterclockwise to pull out the
bulb. Replace the bulb.
2.
Install a new bulb in the reverse
sequence.
Position light bulb
1. Remove the rear sealed cap, pull
out the plug-in parts of lamp
receptacle, and then draw out the
disable bulb.
2. Insert the lamp receptacle of the
new bulb into the mounting hole of
reflector, plug into the plug-in parts
of the lamp receptacle, and then
put on the rear sealed cap.
Front fog light bulb
The car shall be lifted up to replace
the front fog light bulb from the back of
the fog light when you replace the
front fog light bulb; or remove the fog
light to replace the bulb. Thus, it is
recommended that the front fog light
bulb is replaced by the Chery
Authorized Service Station.
Adjusting
screw
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст