Chery Tiggo T11 LHD. Manual — part 73
Service Manual for Chery·Tiggo(T11)Engine Section
19
Upper site of springs
Color identification
Valve spring
Valve guide
Valve oil seal
Lower site of springs
Spiral inner side
Spiral outer side
Idler wheel rocker arm is adopted
in the rocker arm so as to reduce
the abrasion between camshaft cam
and rocker arm
Camshaft is made of spheroidal graphite
iron, of 5-point bearing and no special
bearing.
The
valve
spring
is
non-isometry
structure,
which
may
prevent
sympathetic vibration and
rupture. Please notice
that
the
color-marked
should be upwards and the
larger-distant is upwards.
Spring
section
is
elliptoid, which surface
is shot blasting processed
to
improve
fatigue
resistance.
Service Manual for Chery·Tiggo(T11)Engine Section
12
Valve
Inlet valve is 1.00/limit is 0.5mm
Exhaust valve is 1.2mm/limit is 0.7mm
Valve seat
Working
surface
width
0.9-1.3mm
The valve is of umbrella
structure.
The
intake
valve is similar to the
exhaust valve, but the size
of the former is a little
bigger than the later. Each
cylinder is of four-valve
structure,
which
may
improve
emission
efficiency,
decrease
weight
and
inertia
resistance and extend the
life time of valve and
valve seat. Besides it, it
is of benefit for spark
plug allocation, which
improve burning efficiency
and
reduce
injurant
emission
and
fuel
consumption.
Valve oil seal is of
steel-shelf
and
rubber-ring-spring
tension structure. The
Service Manual for Chery·Tiggo(T11)Engine Section
13
11. Timing Gears Train
Upper Balance Axle Belt
Fitting Mark
Notch around front end cover
Triangle sign on the left balance axle
belt gear
Marks on front end cover
Notch on the crankshaft bearing disc
There is an independent transmission
belt on the upper-left balance axle.
Tension wheel B is located on the
loosened side, which is to adjust
belt tension manually. The teeth
number of drive gear is 38 teeth and
the teeth number of driven gear is 19.
Please note that align the
marks of crankshaft B belt gear
and front end cover and the marks
of upper-left balance axle belt
gear and front end cover when
installing left balance axle
belt gear, which is as shown.
Timing Belt Fitting
Mark
Marks on the crankshaft belt
gear
Notch on the valve cover
Marks on the front end cover
Marks on the crankshaft timing
belt gear
Marks on the oil pump belt gear
Service Manual for Chery·Tiggo(T11)Engine Section
14
Oil Pump Gears Mark
Oil pump driven gear
Marks on drive/driven gear
Oil pump drive gear
Please note that align the marks of camshaft
belt gear and valve cover, the marks of
crankshaft timing belt gear and front end cover
and the marks of oil pump belt gear and front
end cover when installing timing belt. (The
60mm-length screw drive must be inserted into
the lower balance test hole, otherwise turn
around oil pump belt gear and then align timing
mark.)
Please align the marks of
drive/driven gears when installing
oil pump gears as shown.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст