Chery Tiggo T11 LHD. Manual — part 95
T11 Service Manual Transmission
122
Section Ⅸ Transmission Housing Assembly
1. Transmission housing
2. Bearing-gear shifting mechanism
3. Oil seal-differential
4. Adjustment gasket-differential rear bearing
5. Outer race of front/rear bearing of differential
6. Oil baffle
7. Plain washer-oil draining screw plug
8. Oil draining screw plug
9. Plain washer-oil limiting screw plug
10. Oil limiting screw plug
11. Pin GB119
T11 Service Manual Transmission
123
1)
Installation
of
bearing-gear
shifting
mechanism
Press in the bearing till to flush with the
surface of housing.
2)
Installation of the oil seal-differential
Examine that the oil seal has no damage,
apply the lubricating grease on the external
diameter and inner lip mouth of the oil seal,
and then use the special tool to install the seal
into the specified position.
The lubricating grease: Mobilux Ep2
Bearing-gear shifting mechanism
T11 Service Manual Transmission
124
Section Ⅹ Differential Assembly
1. Differential housing
2. The driving gear-speedometer
3. Front/rear bearing of differential
4. Adjustment gasket-axle shaft gear
5. Axle shaft gear
6. Spherical washer-planetary gear
7. Planetary gear
8. Planetary gear shaft
9. Anchor pin-planetary gear shaft
10. The driven gear of main reducing gear
11. Bolt-the driven gear of main reducing gear and the differential housing
T11 Service Manual Transmission
125
1. Disassembly
Disassembly of the differential-front/rear
shaft bearing
2. Assembly
1) Installation of adjustment gasket-axle shaft
gear/axle
shaft
gear/spherical
washer-planetary
gear/planetary
gear/planetary gear shaft
(1) Assemble the spherical washer on the
back of axle shaft gear, and then install
the axle shaft gear on the differential.
Remarks: The adjustment gasket with
intermediate thickness (0.93 to 1.00 mm)
shall be assembled when a new axle shaft
gear is installed.
(2) Place the spherical washer on the back
of any planetary gear to make two
planetary gears engage simultaneously
with the axle shaft gear. Turn these
gears, and, at the same time, install
them on their proper positions.
(3) Insert and install the planetary gear
shaft.
(4) Measure the gear clearance between
the axle shaft gear and the planetary
gear.
The standard value: 0.08 to 0.15 mm
(5) If the measured gear clearance doesn’t
conform to the standard value, select
and install the adjustment gasket, and
then measure the gear clearance again.
Remarks: Adjust the gear clearance till that
the gear clearances of both sides is the
same as each other.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст