Chery A15 / 480 LHD model. Manual — part 78
——To demount the matching plug of the cooling fan.
——To remove the fastening self-tapping screw from
the cooling fan.
——To take the cooling fan out.
Assembly:
——To assemble the cooling fan according to the
disassembly order (the tightening torque of
self-tapping screw is 1.8~2.2Nm)
——To start up the engine and check if the cooling fan
is under normal operation.
Guideline For Disassembly:
——During the disassembly process, you should pay
more attention not to pull A/C pipe to a large extent,
otherwise the A/C pipe shall crack and deform.
EXPANSION RESERVOIR
——To pry out the protecting hood of expansion
reservoir by using a screw drive.
——To demount the fastening bolts of the expansion
reservoir by using M10 sleeve.
——To pull out the plug of liquid level sensor.
——To take the expansion reservoir out.
Disassembly:
——To demount the water pipe connecting with the
expansion reservoir.
——To demount the left and right wind boards by M10
sleeve.
——To take out the radiator.
Assembly:
——To assemble the expansion reservoir according to
the order opposite to the disassembly order(the
tightening torque of self-tapping screw is
4.0~5.0Nm).
——To refill coolant.
ASSEMBLY OF RADIATOR
Disassembly:
——To discharge coolant (refer to the coolant discharge
process)
——To demount the cooling fan (refer to the
disassembly process of the cooling fan).
——To take out the radiator
——To install the radiator onto the front transom and
put it straightly towards the positioning hole.
——To install the left and right tensioned plates of the
radiator, and tighten the bolts of the plates with
tightening torque of 5±1Nm.
Assembly:
——To assemble the radiator according to the order
opposite of the disassembly order.
——To install the 2 wind boards onto the radiator by
using self-tapping screws with their tightening
torque of 6~7Nm.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст