Chery A15 / 480 LHD model. Manual — part 41
REMOVAL & INSTALLATION OF FUEL FILLER CAP
REMOVAL:
----Loosen the two screws between the filler
cap and car body.
INSTALLATION:
----Install in the reverse order of installation
ADJUSTMENT:
----Keep the size at (4±0.5)mm and flatness
error between cap rim and the fender at
±0.5mm, which shall not affect the
appearance.
REMOVAL
&
INSTALLATION
OF
EXTERIOR REARVIEW MIRROR
REMOVAL:
----In
removing
the
mirror,
relevant
instructions shall be followed to remove
front door trim panel (refer to REMOVAL
& INSTALLATION OF FRONT DOOR
TRIM PANEL)
----Remove inner triangular block of the
mirror.
----Remove the three screws connecting the
mirror and door trim panel. Pull the mirror
connector off to remove the mirror.
INSTALLATION:
----Install in the reverse order of removal.
Tightening torque for bolts is 3±0.3N·m.
REMOVAL
&
INSTALLATION
OF
RADIATOR GRILLE
REMOVAL:
----Take out the four bolts between the grille
top and front end panel to remove radiator
grille as shown in the right figure.
INSTALLATION:
---- Install in the reverse order of removal.
Tightening torque for bolts is 3.5±2N·m.
REMOVAL
&
INSTALLATION
OF
TRUNK LID TRIM PANEL
REMOVAL:
----Remove the screw of trim panel frame.
----Pry open the plastic clip with screwdriver to
remove trunk lid trim panel.
INSTALLATION:
---- Install in the reverse order of removal.
REMOVAL & INSTALLATION OF ROOF
TRIM MOULDING
REMOVAL:
----Pry the moulding starting from where back
window is with a plastic wedge. Loosen the
clips of drip channel by hand and then open
them with screwdriver.
INSTALLATION:
---- Install in the reverse order of removal.
NOTE:
----All clips can be used once only.
REMOVAL
&
INSTALLATION
OF
FRONT WHEEL HOUSE INNER FENDER
REMOVAL:
----Loosen the screw between front wheel
house and its inner fender.
INSTALLATION:
---- Install in the reverse order of removal.
REMOVAL & INSTALLATION OF REAR
WHEEL HOUSE INNER FENDER
REMOVAL:
---- Loosen the screw between front wheel
house and its inner fender.
INSTALLATION:
---- Install in the reverse order of removal.
REMOVAL & INSTALLATION OF FRONT BUMPER
REMOVAL:
----Remove wheel house inner fender (refer to
REMOVAL & INSTALLALTION OF
WHEEL HOUSE INNER FENDER)
----Remove the screw of wind deflectors
under front bumper as shown in the right
figure. Two wind deflectors, one each
side.
----Remove
radiator
grille
(refer
to
REMOVAL & INSTALLATION OF
RADIATOR GRILLE).
----Remove the bolts between bumper bracket
and front floor cross member.
----Slide the bumper forward until it is
disconnected with the side bracket.
INSTALLATION:
---- Install in the reverse order of removal.
NOTE:
----Tightening torque for bumper bracket is
82±8N·m.
REMOVAL OF SIDE BRACKET
----Take out the clip of expansion seat inside
the fender with the help of auxiliary tool to
remove side bracket.
----The clearance between fender apron and car
body, rear wheel trim panel shall be not
more than 1mm during installation.
REMOVAL OF BRACKETS
----Loosen the bolts between bumper and its
brackets to remove the brackets.
----Install the bumper in the reverse order of
removal. Note that tightening torque for
the bolt between the brackets and floor
side member is 25N·m. Place the brackets
horizontally with ground.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст