Chery QQ6 (S21) / S12LHD. Manual — part 155
107
III. Engine Compartment Dimensions
No
Name
Diameter
A/B
Front bumper crossbeam mounting hole
Φ11
C/D/E/F
Headlight mounting hole
Φ7
G/H
Engine right suspension bracket mounting hole
Φ13
I/J
Installation of fender
Φ8
K/L
Shock absorber mounting hole
Φ76
108
IV. Various Opening Dimensions
V. Windshield Dimensions
Joint between
the front wall
upper
cover
assembly and
Inner A-pillar
plate
(right
and left are
the same)
Corner
where
the
roof
cover
and
side
wall
join
(right=left)
Up-turning
point of the
rear
windshield
(right=left)
Down-turn
ing
point
of the rear
windshield
(right=left)
109
Chapter X Harness
Section I Battery Negative Harness
I. Harness Sketch
II. Instructions on Main Connectors
No
Connector Name
Pins
Connection
Remark
1
Hole type joint
1
Battery Negative
2
Vehicle
body
ground
1
Vehicle body
Below left-front
fender
Vehicle body earth
Hole type
Connector
110
III. Removal and Installation of Battery Harness
Part number: S12-3703010AC
(I). Preparations
Tools: 10#. 13# wrench
(II). Notes
Make sure to disconnect the power supply when disassembling the
electrical components and harnesses.
Ignition switch must be OFF.
(III). Removal Steps
1. Removal
1.1. Use a 10# wrench to remove the battery positive.
1.2. Use a 10# wrench to loosen off the battery negative.
1.3. Use a 13# wrench to loosen off the battery negative harness
Remove the battery negative harness at the vehicle body ground
wire.
2. Installation
The installation steps are reverse to those for removal.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст