Chery QQ6 (S21) / S12LHD. Manual — part 47
14
4.10 If the rear brake is found too tight during driving,
adjust the length of push rod: Turn it in the cloclwise
direction to eliminate the friction.
4.11 Remove three bolts as shown in the picture wit a 10#
box wrench.
1.12 Take off the brake wheel cylinder, and detach and
check whether it is in good condition.
4.13 If it is necessary to check the brake drum
bearing, remove the lock nuts as shown in the
picture with a 32# sleeve and a torque spanner,
and take off the brake drum bearing.
Torque: 250±10 N.m
5. Installation Step
Refer to Removal Step.
Bolts
Lock Nuts
15
IV. Adjustment and Replacement of Hand Brake
1. System Composition Diagram
1. Handle 2. Fixing Bolt 3. Control Cable 4. 5. Rear Right/Left Wheel Control Cable
2. Preparation
Tools: ratchet wheel, lug bar, 10#, 13#, 14#, 16# sleeve, 10#,
13#, 14# box wrench, vice, torque spanner, right-angled screwdriver.
3. Precautions
3.1 Please wear necessary labor protection supplies to avoid accidents.
3.2 When carrying out disassembly and assembly of elastic element, avoid the bounce that will
cause injury.
3.3 If the hand brake is removed or reinstalled near the exhaust pipe, wait for a period of time until
the temperature of exhaust pipe falls down to the normal value so as to avoid the injury.
4. Removal/Installation Step
4.1 Refer to the removal/installation step of rear brake, and
loosen the hand brake control cable.
T
o
R
ea
r R
igh
t B
ra
k
e A
ssy
T
o
R
ea
r L
e
ft
B
ra
k
e
A
ssy
16
4.2 Remove the bolt here from the hand brake control cable
fixed support with a 13# box wrench.
4.3 Remove the other bolts from the hand brake control
cable fixed support with a 10# box wrench or a 10# socket
wrench.
17
4.4 Remove the hand brake control cable at the other side
with the same method.
4.5 Remove two fixing bolts from the driver’s seat with a
16# socket wrench, and then take off the seat.
4. 6 Remove all fix screws from the auxiliary instrument
panel assy with a cross screwdriver, and then take off the
auxiliary instrument panel assy.
4.7 Remove two hand brake fixing bolts as shown in the
picture with a 10# socket wrench.
4.8 Loosen two control cable fixing screws with a 14# box
Wrench, and then take off the guide plate.
Guide
Plate
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст