Chery QQ6 (S21) / S12LHD. Manual — part 42
165
Section 10 Back Door Harness
I. Schematic Diagram of Harness
后背门接
触开关
牌照灯
搭铁
高位制动灯
接后除霜正极线束
接室内线束
To Interior Harness
High-Mount Stop Lamp
To Rear Defroster Positive Harness
License Plate Lamp
Ground
Back Door Contact Switch
166
II. Main Connectors Description
No
Connector Description
Number
of Pin
Connection
Remark
1
Connect
to
interior
harness connector
6
Interior Harness
2
High-mount stop lamp
connector
1
High-mount stop lamp
3
Connect to rear defroster
positive harness connector
1
Rear defroster positive
harness
4
Back door harness ground
1
Body
At
back
door
paintwork
5
License
plate
lamp
connector
2
Side license plate lamp
6
Back door contact switch
connector
1
Back
door
contact
switch
167
III. Disassembly/Reassembly of Back Door
Inner Harness
Part Number: S21-3724160
(I). Preparation
Tools:
socket wrench, cross screwdriver, flat head screwdriver
(II). Precautions
DO NOT apply too big force when the harness is going
across the body paintwork hole so as to avoid the
harness breakage and short-circuit.
Power OFF before the electrical elements and
harnesses are removed.
The ignition switch must be in OFF state.
(III). Removal Procedure
1. Removal.
1.1.1.
Remove
the
C
pillar
trim.
(See
Disassembly/Reassembly of Ceiling)
1.1.2. Pull out the back door harness connector.
1.1.3. Remove the fix screws from the rear door
contact switch with a cross screwdriver.
168
1.1.4. Pull out the connector of rear door contact
switch.
1.1.5. Remove the back Door Inner ornament plate.
(See Disassembly/Reassembly of Luggage Boot)
1.1.6. Pull out the connector of rear defroster positive
harness, and connector to the high-mount stop lamp
circuit.
1.1.7. Pull out the connector of high-mount stop lamp,
and then remove the harness from high-mount stop
lamp.
1.1.8. Pull out the connector to the license plate lamp.
1.1.9. Remove the grounding point from the back door
harness.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст