Chery QQ6 (S21) / S12LHD. Manual — part 146

2.6. Use pliers to remove the inlet/outlet water pipes of the
evaporator and pull out the pipes.
Note: Coolant will flow out from the water pipe, pay attention to
recycle the coolant.








2.7. Loosen off the 8 fixing nuts that fix the evaporator assembly on
the plate work from the front compartment (See the following
figures for detailed positions).

2.8. Take the evaporator assembly from the driver’s cab..

3. Installation of Evaporator Assembly

The installation steps are reverse to those for removal.

4. Removal and Installation of Evaporator Interior

Preparation of Tools: cross head screwdriver, sleeve wrench.

1. Replacement of Blower

1.1. Removal Steps
1.1.1. Disassemble the blower motor, relay and motor speed
regulation module plug.

1.1.2. Remove the blower cooling jacket.







1.1.3. Push down the clip and drag out the blower clockwise.

1.2. Installation Steps
The installation steps are reverse to those for removal.

2. Removal and Installation of Blower Speed Regulation Module

2.1. Removal Steps
2.1.1. Pull out the speed regulation module plug.







2.1.2. Use a cross head screwdriver to loosen off the 2 fixing screws
on Speed Regulation Module.









2.1.3. Pull out the speed regulation module.




2.2. Installation Steps
The installation steps are reverse to those for removal.

3. Removal and Installation of Heater Exchanger

3.1. Removal Steps
3.1.1. Disassemble the evaporator assembly. (See Removal of
Evaporator Assembly)
3.1.2. Disassemble the air-conditioner harness. (See Removal of
Air-conditioner Harness)
3.1.3. Loosen off the two fixing screws and remove the heater
exchanger shield.