Chery A15. Manual — part 223
Chery A15 Maintenance Manual
Annex I
ABS FAQ
1. What is ABS?
ABS is an acronym for “Anti-lock Brake System”, which serves to ensure optimal
braking distance and excellent brake stability and steerability on all kinds of road
surfaces.
2. What does ABS do for me?
ABS offers an important safety advantage by preventing the wheels from locking
during emergency braking situations which will cause loss in steering control of front
wheel and offtracking or side skidding of rear wheel, allowing drivers to maintain
control over steering and operate vehicles more effectively to steer around obstacles.
3. How do I know if the vehicle I’m driving has ABS?
Two methods recommended: 1. check your dashboard for a shortly lighted ABS
warning light; or 2. simply ask your dealer.
4. How does ABS work?
The electronic control unit in ABS modulates brake pressure at all four wheels
through an electromagnetic valve according to signals sent by wheel speed sensors
and some certain control logics, just like the way an experienced driver pumps brake
pedal, the difference is that a computer reacts much quicker than human brains, and
the effect is also much better.
5. How do I know my ABS is working?
You will hear a mechanical sound and feel some pulsation in brake pedal when ABS
is working. It is important not to take your foot off the brake pedal when you hear
noise or feel vibrations, but instead continue to apply firm pressure.
Chery A15 Maintenance Manual
6. Do cars with ABS stop more quickly than cars without it?
Under most conditions the answer is yes, especially on snow-covered or wet road
surfaces. However, don’t forget to steer around any obstacles you see on the roads.
7. What if ABS fails?
ABS warning light goes on once ABS fails. In this case ABS is deactivated, while
conventional brake system remains undamaged, which means you still can brake
following normal procedure.
8. When does ABS warning light go on?
ABS warning light goes on for about 1.7 seconds after starting vehicle, and then goes
out. After that, the light will go on only when ABS failure occurs. Therefore, you are
supposed to go to service station once the light goes on again, and any DIY repair of
ABS is not recommended.
Chery A15 Maintenance Manual
Annex II
“Four Dos” and “Four Don’ts” of ABS
“Four Dos”
Do keep your foot on the brake pedal. Maintain firm and continuous pressure on the
brake while steering to enable four-wheel ABS to work properly.
Do allow enough distance to stop. Allow three seconds or more braking time when
driving under good conditions after vehicles. Allow more time if conditions are
hazardous.
Do practice driving with ABS. Become accustomed to pulsations that occur in the
brake pedal when ABS is activated. Empty parking lots or other open areas are
excellent places to practice emergency stops.
Do consult the Driver’s Manual for additional driving instructions on the anti-lock
brake system.
Four “Don’ts”
Don’t drive an ABS-equipped vehicle more aggressively than vehicles without ABS.
Driving around curves faster, changing lanes abruptly or performing other aggressive
steering maneuvers is neither appropriate nor safe with any vehicle.
Don’t pump the brakes. In ABS-equipped vehicles, pumping the brake turns the
system on and off, which might result in weakening braking performance and increase
of braking distance. ABS pumps the brakes for you automatically at a much faster rate,
and allows better steering control.
Don’t forget to steer. ABS enables drivers to steer in emergency braking situations,
but the system itself does not steer.
Don’t be alarmed by mechanical noises and/or slight pedal pulsations while applying
the brake in an ABS-equipped vehicle. These conditions are normal and let the driver
know ABS is working.
Chapter One General Description
One. Engine Assembly Drawing
Two. Basic data of engine
Car model
SQR7162
Engine model
Tritec 1.6L
Number of cylinders
4
Cylinder diameter (mm)
77
Stroke (mm)
85.8
Displacement (L)
1.6
Compression ratio
10.5
Ignition sequence
1 – 3 – 4 – 2
Engine property
Net power:
Net torque:
Fuel consumption:
> 83KW @ 5600rpm
> 146 Nm @ 4500~5000 rpm
< 341 g/KW*h (1600r/min, 2.4bar)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст