Chery A15. Manual — part 191
Chery A15 Maintenance Manual
Check the vehicle body with the frame of the special measuring system (fixed mechanical
tools are used during the measurement)
Chery A15 Maintenance Manual
Chapter Two Engine Hood and Luggage Compartment
I. Engine housing cover (engine hood)
Disassembly, installing and adjustment
1.Disassemble the engine hood, the
windscreen cleaner nozzle.
2. Loosen four screws for fixing the engine
hood and movable hinge, two on each side.
Another operator disassembles the engine
housing cover.
Installing procedures are in the reversed
order.
3. There are trough holes on hinge holes,
which can be used for final adjusting of
engine hood. They are 4 ± 0.5mm with
identical heights and smooth transition in
order that clearances around front cover are
even.
In case that transverse adjustment of the
engine hood is necessary, loosen the
connecting bolt as shown in the figure and
transversely move engine hood following
the hinge holes. Measure the distance after
moving the engine hood for several times.
Keep on moving until required value is
achieved.
Chery A15 Maintenance Manual
4. In case that longitudinal adjustment of
engine hood front is necessary, adjust the pin
which is on the rubber baffle block to align
the fender with the engine hood.
Tightening torque for upper bolts of engine
hood lock is 14±2N.m.
II. Disassembling and installing of the engine hood lock
Disassemble the lock:
1.Disassemble the front radiator grill. First
disassemble the four set screws for the
central grill and then disassemble the front
end board.
When disassembling the lock, first loosen the
lid on the opening for the drag line and
remove the rivet between the lock and the
front end board.
3. Disassemble the pin and the lock claw by
removing two setscrews which fix them on
the engine hood.
Chery A15 Maintenance Manual
4. Disassemble the lock handle by removing
two set screws between the control plate and
the fenderboard.
The installing procedures are in the
reversed order. The tightening torque for
the bolts is 14±2N.m
III. Rear door (tailgate)
Disassembling, installing and adjusting.
1. It is necessary to remove the bent hanging
ribbon and the rear bracket when
disassembling the rear door (tailgate).
2. Remove the spring for lifting and fixing the
door, one end of which is fixed on the door
and the other is fixed on the drip rail of the
sliding pole.
3. When disassembling the gas spring, move
the lock claw with a screw driver. Extract
the gas spring out of link pin of the set bolt.
If this gas spring is to be reused, the lock
claw can’t be completely extracted from
the link pin housing. Otherwise the lock
claw may be damaged.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст