Chery A15. Manual — part 20
THERMOSTAT
Disassembly:
——To unscrew 3 M6×40 bolts and then demount the
bolts;
——To demount thermostat chassis and thermostat
assembly.
——To pry out the spring clamps by using chisel or
screwdriver.
——To take the thermostat out;
——To clean up the thermostat;
E-7
——To take the seal ring out, and replace it if it being
worn and torn.
——To demount the gasket from the thermostat chassis.
(
To replace with new gasket if it is worn and
torn, and allow no repeated use.)
——To measure the thermostat opening temperature
under hot water.
Assembly:
——To clamp the thermostat and then put the gasket
into the thermostat aperture.
——To install thermostat (the side with spring facing
outward).
——To embed spring clamp to ensure the clip within
the thermostat chassis slot;
——To mount new gasket onto thermostat chassis;
——To mount the thermostat chassis and thermostat
assembly into the aperture at the rear side of engine
cylinder head, and screw up the bolt by hand to
9—12N.m.
E-8
WATER TEMPERATURE SENSOR
Disassembly:
——To demount water temperature sensor (at the
exhaust pipe flank and under the lifting eye).
Assembly:
——To apply Letai 243 glue on the screw thread,
screw up the bolt to 7.0—10.0Nm before
installation.
Checking:
Water temperature sensor is a negative temperature coefficient sensor, which is composed of
a thermal resistor. The resistance value of the resistor shall decrease as the engine temperature
rises. The variation is detailed in the following table:
Temperature (°C)
Resistance Value (Ω)
-20 29,125
-10 16,660
0 9,790
+20 3,748
+25 3,000
+60 747
+80 377
+100 204
+120 117
COOLING FAN
Disassembly:
——To disconnect the negative terminal of battery;
E-9
——To demount the matching plug of the cooling fan.
——To remove the fastening self-tapping screw from
the cooling fan.
——To take the cooling fan out.
Assembly:
——To assemble the cooling fan according to the
disassembly order (the tightening torque of
self-tapping screw is 1.8~2.2Nm)
——To start up the engine and check if the cooling fan
is under normal operation.
Guideline For Disassembly:
——During the disassembly process, you should pay
more attention not to pull A/C pipe to a large extent,
otherwise the A/C pipe shall crack and deform.
E-10
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст