Chery A11. Manual — part 46
The manual of 4HP14 A/T removing & installing CHERY AUTOMOBILE CO., LTD
1.6、Transmission general check
The following points must be checked:
Correct oil level
Checking fluid level when engine idle.
Checking fluid level after fluid temperature rises to 80ºC.
Fluid level must be between Max. and Min. mark.
Low fluid level
Engine running, but no power transferred to transmission, pump does not transfer power.
Abnormal sound from transmission when turning.
High fluid level
Air bubble occurs in transmission, causing power consumption. High fluid temperature when operating in high
speed. Oil evaporates into atmosphere.
Proper engine adjustment
Seeking proper idle speed from whole vehicle manufacturer.
Power transmission (forward and reverse)
It is required to properly adjust the power transmission mechanism.
Stalling speed
Stalling speed range:2100±150rpm
Shifting point
No early or late shifting.
Shifting quality
Adjust
throttle cable
Correct adjustment to accelerating unit is required.
Noise
Noise detection
-31-
The manual of 4HP14 A/T removing and installing CHERY AUTOMOBILE CO., LTD
2、A/T internal disassembling
2.1、Assembly removing
Support transmission assembly with 5 x 46 000
244 braket and drain oil.
Remove converter carrier.
Remove torque converter with special tool 5 x 56
000 090.
NOTE: when removing torque converter, prevent
oil leaking as possible and do not damage oil
pump bushing and sealing ring lip.
Loosen oil pan mounting bolt.
Tool: Using 27# inner socket spanner, remove oil
pan and gasket.
-32-
The manual of 4HP14 A/T removing & installing CHERY AUTOMOBILE CO., LTD
Remove 10 valve plate mounting bolts with
10 big size bolt head.
Tool: 27# quincunx socket spanner.
Turn over transmission by 90 degree, remove
17 mounting bolts on the converter housing.
Tool: 13# socket spanner
Remove converter housing.
NOTE: Speedmeter drive gear may drop off.
Remove the gasket
-33-
The manual of 4HP14 A/T removing and installing CHERY AUTOMOBILE CO., LTD
Remove differential and drive gear of the
speedmeter.
Remove central seat, oil pump and brake C
assembly.
Tool: 27# quincunx socket spanner.
NOTE:
During disassembling, hold transmission
firmly.
Remove the thrust washer C (with flang edge)
and adjust washer.
-34-
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст