Chery A11. Manual — part 74
CHERY AUTOMOBILE CO., LTD Automatic Transmission Fault Diagnosis Manual
43
Gear
djustment procedure:
The adjustment of gearshift
cable is important to the
compliance of the position of the
shift lever with that of the gear
the shift lever to
heck if the
in position P.
2.
strument panel,
3.
. Loosen the gear switch and tighten the
bolt;
. Pull the gear shifter arm to the limit,
i.e. position P;
hift cable and
Fix the gearshift cable with the
adjusting bolt and nut;
Install the gearshift box, gear position
display board;
Install the battery.
shift cable adjustment
A
shifter arm. Pull
position P and then c
gear shifter arm is
If not, adjust the gearshift cable
in accordance with the following
procedure:
1. Remove the battery,
Remove the in
shift box cover and shift box;
Pull the shift level to position P;
4
5
6.Tighten after the gears
shift level is connected;
7.
8.
9.
CHERY AUTOMOBILE CO., LTD Automatic Transmission Fault Diagnosis Manual
Air throttle cable removal and assembly
isassembly procedure:
Remove the battery;
Remove the cable ends from
the air throttle’s swing arm;
3.
ehicle;
n and gasket.
Remove the valve plate
assembly;
Rotate the air throttle cable and
remove the cable ends;
7.
8.
hrottle cable from
D
1.
2.
3 Lift the v
4. Remove the oil pa
5.
6.
Lower the vehicle ;
Remove air t
the transmission.
44
CHERY AUTOMOBILE CO., LTD Automatic Transmission Fault Diagnosis Manual
Assembly procedure:
Install the air throttle cable;
2.Install the air throttle cable on
the air throttle’s swing arm;
Lift the vehicle;
Rotate the cam by certain
degree and install the cable;
Install the control valve plate
t;
.Lower the vehicle;
1.
3.
4.
5.
assembly;
6.Install the oil pan and gaske
7
8.Install the battery.
45
CHERY AUTOMOBILE CO., LTD Automatic Transmission Fault Diagnosis Manual
Air throttle cable adjustment
Ad ustment procedure:
j
Adjust the gap between the idle
positioning block and the
e.
2.
he
sitioning block and the
T;
3.
ir throttle cam
isassembly procedure:
. Lift the vehicle;
oil pan and gasket;
valve plate
throttle cable
5.
wl spring for cam
6.
1.
adjusting turnbuckl
Permissible gap: 0~1mm
Check the distance between t
idle po
adjusting turnbuckle when WO
Distance scope: 39.0~40.0mm
If the distance exceeds this scope,
adjust the adjusting nut;
A
D
1
2. Remove the
3. Remove the control
assembly;
4. Remove the air
from the cam;
Remove the pa
positioning and air throttle cam;
Remove the return spring on the
cam;
46
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст