Chery A11. Manual — part 104
CHERY AUTOMOBILE CO., LTD Automatic Transmission Fault Diagnosis Manual
52.
. Install the oil pump assembly
and fix it with bolts; The torque
m.
. Install the axial gap detector;
Put the adjusting washer and
thrust washer onto the input
shaft;
53
on the bolt connecting the
middle seat with the pump
body: 10N
54
163
CHERY AUTOMOBILE CO., LTD Automatic Transmission Fault Diagnosis Manual
55. Install the dial indicator and
. The gap should be between
0.1mm to 0.3mm. Otherwise,
select the washer with different
depth and adjust the gap into
permissible scope;
. Install the differential assembly;
ote:
Remove the cases for the
lve plate assembly and
odometer drive gear in order to
just the differential’s gap.
. Install the differential
adjuster;
reset
it to zero;
56
57
N
va
ad
58
164
CHERY AUTOMOBILE CO., LTD Automatic Transmission Fault Diagnosis Manual
5
clockwise when installing
the bearing;
Verify the torque again:
60. Measure the distance from
the bearing’s outer racer to
the case plane with a depth
9. Rotate the drive drum
165
gauge;
61. Measure with a depth gauge
the distance from the
odometer drive gear case’s
top plane to the surface with a
bolt hole.
CHERY AUTOMOBILE CO., LTD Automatic Transmission Fault Diagnosis Manual
166
depth is determined
the
uter racer and the
case plane is 10.2mm. The distance
from the odometer drive gear case
to the bolt hole surface is 8.65mm.
The washer is 1.65mm thick;
63. Install the converter case and
washer and fix them with bolts:
The bolts’ tightening torque:
23Nm
64. Use the transmission fluid to
lubricate clutch B drum.
Tighten the adjusting bolt on
the brake band with a
tightening torque of 10Nm.
Note: Rotate clutch B drum while
tightening the brake band to ensure
that it is installed to the correct
position;
65. Turn the adjusting bolt
counterclockwise by 3mm.
Note: The gap between the
adjusting bolt and brake band is
.9mm~1.2mm;
62. In accordance with the measurements, install one or two washers between the differential and
the odometer drive gear case. Adopt the combination of different depths in order to get the
most approximate value. The
washer’s
by the following formula:
S=A-B+0.1mm
For example: The distance between
bearing’s o
The washer’s thickness is S:
S=10.2-8.65+0.1=1.65mm;
0
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст