Chery A11. Manual — part 148
Maintenance Manual for Chery·Windcloud
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
Sunroof
Assembling procedure
4.3.5 Slide a new glass plate into mechanism group with
both sides being parallel.
4.3.6 Fix glass plate fixing pin and turn it to a 90º
position.
4.3.7 Push the fixing pin to its position.
4.4 Replacing rubber sealing strip
4.4.1 Fully open sunroof.
Page 17 of 37
Maintenance Manual for Chery·Windcloud
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
Sunroof
4.4.2 Detach the glass plate lock pin from fixed driving
base with a screwdriver as shown in the figure,
then take off lock pin (the same with the other
side).
4.4.3 Turn the glass plate fixing pin clockwise to a 90º
position with a minus screwdriver and take it off
(the same with the other side).
4.4.4 Carefully pull the glass plate out of mechanism
group with both sides being parallel.
4.4.5 Take off the worn rubber sealing strip from the
middle part of front end of sunroof frame with a
minus screwdriver.
Page 18 of 37
Maintenance Manual for Chery·Windcloud
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
Sunroof
4.4.6 Remove the residual sealant and clean the slot.
Assembling procedure
4.4.7 Apply a layer of silica gel with diameter of 3mm on
the edge of upper frame, and apply two layers
under glass plate holding piece.
4.4.8 Place the new rubber sealing strip on the upper
frame with the concaved center of sealing strip
aligned with the center of glass plate holding piece.
Carefully stretch this part of sealing strip when
installing.
4.4.9 Push the sealing strip 1mm into the slot in such
order: middle front, both sides, then rear. Note: do
not stretch rubber sealing strip.
Page 19 of 37
Maintenance Manual for Chery·Windcloud
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
Sunroof
4.4.10 Fully push the sealing strip into the slot. Make
sure the sealing strip is installed in position.
4.4.11
Slide the glass plate into mechanism group with
both sides being parallel.
4.4.12
Fix glass plate fixing pin and turn it to a 90º
position.
4.4.13 Push glass plate locking pin into place.
Page 20 of 37
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст