Chery A11. Manual — part 120
Wiring
diagram
Key words
1.ECU anti-theft device
13.coolant temperature sensor
2.knock sensor
14.coolant temperature meter
3.ignition coil
15.coolant overheat indicator
4. fuel pump
16.idle step motor
5.fuel injector
17.Top Dead Center/speed sensor
6.oxygen sensor
18.A/C
7.carbon canister solenoid
19.Fan relay (first stage speed)
8.ignition switch
20.Fan relay(second stage speed)
9.System failure warning indicator
21.diagnostic socket
10. speedometer
22.relay
11.air pressure/temperature sensor
22.relay
12 throttle position sensor
23.battery
Diagnostic Socket
Vehicle is equipped with lots of ECU self-diagnostic functions; therefore a single
16-pin connector (called EOBO type connector) is used for performing self-diagnostic.
Connect diagnostic socket and tester with an appropriate adapter. Select specified diagnostic
cable upon used ECU.
Appendix 2:Electrical Components Specification
Part : Electrical
fuel injector
Code:IWP116
Internal expanded view
Specification:
Fuel injector shape, single hole
Operating temperature:-30℃~+110℃
Nominal resistance:13.8~15.2Ω10%(at
20℃)
voltage:12V
fuel injection pressure:3.5bar
Part : Throttle
valve position
sensor
(irreplaceable)
code:IPF2C
Internal expanded view
A=Negative
B=Power supply (+5V)
C=signal
Specification:
Effective electric power angle:90°±2
Mechanical angle:105°±4°
Full mechanical travel:110°±8°
Temperature operating range:-30℃~
+125℃
Resistance between A and B =1200Ω
20%(at 23℃)
Part:Electric fuel
injector
Code:BQE02
Internal expanded view
Specification:
Primary coil resistance (A-B or C-B)
0.4Ω±10%(at 23°±5°)
HTtap secondary coil resistance (1—4
cylinder or 2—3 cylinder);
4900Ω10%(at 23°±5°)
Connector
Connect
or
Connect
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст