Chery SQR 7160 sedan. Manual — part 112
CHERY AUTOMOBILE CO., LTD Automatic Transmission Fault Diagnosis Manual
. Turn the gear to reset the gauge
32.
R
e driven shaft’s
fixing device KA-000-288;
.
Turn the adjusting bolt
clockwise by 270 degree. Then
turn the gear until the gauge
index is calibrated. Get the
reading X;
. Install an adjusting washer
under the auxiliary back output
gear. The washer’s depth is
determined by the following
formula:
1.75mm-(Xmm-0.06mm)
The
1.75mm-(0.46mm-0.06mm)
.355mm in accordance with this formula,
mong which, 1.75mm and 0.06mm are all adjusting coefficients;
. Remove the gauge. Replace the washer on auxiliary back output gear, if necessary.
. Knock the flange of the lock bolt on the auxiliary back output gear and sink it into the gear pit.
. Install the side cover;
. Turn the transmission by 180
degree, as shown by the figure;
bearing and adjusting washer.
31
index to zero;
emove th
33
34
S=
For example:
reading is 0.46mm and then,
S=
=1
A
35
36
37
38
39. Install the thrust washer, thrust
158
CHERY AUTOMOBILE CO., LTD Automatic Transmission Fault Diagnosis Manual
40
159
.
Install the planetary gear
. Install the sun gear into the
. Install the drive drum so that
the inner racer engages with the
sun gear;
mechanism;
41
planetary gear mechanism;
42
CHERY AUTOMOBILE CO., LTD Automatic Transmission Fault Diagnosis Manual
43.
Install the thrust washer,
thrust bearing and thin disk
washer into the drive drum;
. Install the sun gear shaft:
ote: Correct installation of the sun
ar: The drive drum could only
tate towards the sun gear at one
rection.
. Put the washer, thrust bearing
and thrust washer on the
middle shaft. Then install the
entire middle shaft assembly
on the transmission;
44
N
ge
ro
di
45
160
CHERY AUTOMOBILE CO., LTD Automatic Transmission Fault Diagnosis Manual
46.
Put the washer and thrust
bearing on top of the middle
shaft;
47. I
ro
nuously when
with
clutch E case and sun gear shaft
rack that are integrated with the
input shaft.
ble clutch A and clutch
B together.
nstall the input shaft and
tate it conti
assembling. Engage it
48. Assem
161
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст