Chery SQR 7160 sedan. Manual — part 129
(3) Unstable idle speed
No. Problem
Causes
Actions
Air leakage
Fasten throttle valve body mounting screw.
Failed idle control valve
Repair or replace the throttle valve body
Failed throttle position
sensor
Check throttle opening. Check if throttle position
sensor operating parameter within specification.
Check if throttle cable installed correctly.
Move throttle and check if throttle stuch.
Check throttle opening (angle is within 0~0.6 at
throttle is closed)
1
throttle
valve
body
Abnormal throttle
opening
If throttle angle is correct, check if throttle position
sensor connector contact is good.
Wiring
diagram
Key words
1.ECU anti-theft device
13.coolant temperature sensor
2.knock sensor
14.coolant temperature meter
3.ignition coil
15.coolant overheat indicator
4. fuel pump
16.idle step motor
5.fuel injector
17.Top Dead Center/speed sensor
6.oxygen sensor
18.A/C
7.carbon canister solenoid
19.Fan relay (first stage speed)
8.ignition switch
20.Fan relay(second stage speed)
9.System failure warning indicator
21.diagnostic socket
10. speedometer
22.relay
11.air pressure/temperature sensor
22.relay
12 throttle position sensor
23.battery
Diagnostic Socket
Vehicle is equipped with lots of ECU self-diagnostic functions; therefore a single
16-pin connector (called EOBO type connector) is used for performing self-diagnostic.
Connect diagnostic socket and tester with an appropriate adapter. Select specified diagnostic
cable upon used ECU.
Appendix 2:Electrical Components Specification
Part : Electrical
fuel injector
Code:IWP116
Internal expanded view
Specification:
Fuel injector shape, single hole
Operating temperature:-30℃~+110℃
Nominal resistance:13.8~15.2Ω10%(at
20℃)
voltage:12V
fuel injection pressure:3.5bar
Part : Throttle
valve position
sensor
(irreplaceable)
code:IPF2C
Internal expanded view
A=Negative
B=Power supply (+5V)
C=signal
Specification:
Effective electric power angle:90°±2
Mechanical angle:105°±4°
Full mechanical travel:110°±8°
Temperature operating range:-30℃~
+125℃
Resistance between A and B =1200Ω
20%(at 23℃)
Part:Electric fuel
injector
Code:BQE02
Internal expanded view
Specification:
Primary coil resistance (A-B or C-B)
0.4Ω±10%(at 23°±5°)
HTtap secondary coil resistance (1—4
cylinder or 2—3 cylinder);
4900Ω10%(at 23°±5°)
Connector
Connect
or
Connect
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст