Chery SQR 7160 sedan. Manual — part 84
CHERY AUTOMOBILE CO., LTD Automatic Transmission Fault Diagnosis Manual
Air throttle cable adjustment
Ad ustment procedure:
j
Adjust the gap between the idle
positioning block and the
e.
2.
he
sitioning block and the
T;
3.
ir throttle cam
isassembly procedure:
. Lift the vehicle;
oil pan and gasket;
valve plate
throttle cable
5.
wl spring for cam
6.
1.
adjusting turnbuckl
Permissible gap: 0~1mm
Check the distance between t
idle po
adjusting turnbuckle when WO
Distance scope: 39.0~40.0mm
If the distance exceeds this scope,
adjust the adjusting nut;
A
D
1
2. Remove the
3. Remove the control
assembly;
4. Remove the air
from the cam;
Remove the pa
positioning and air throttle cam;
Remove the return spring on the
cam;
46
CHERY AUTOMOBILE CO., LTD Automatic Transmission Fault Diagnosis Manual
Assembly procedure:
Put the return spring on the cam;
Install the cam and fix with the
pawl spring;
The tightening torque for the
pawl spring’s positioning bolt:
3.Install the air throttle cable;
4.
late
Dis
cedure:
ry’s negative
2.
utral start
switch’s wiring harness.
1.
2.
10Nm
Install the control valve p
assembly
5.
Install the oil pan and its
gasket;
6. Lower the vehicle.
Neutral start switch
assembly pro
1. Remove the batte
terminal;
Remove the ne
47
CHERY AUTOMOBILE CO., LTD Automatic Transmission Fault Diagnosis Manual
3.Loosen the connecting bolt between
the neutral start switch and the case;
Remove the neutral start switch;
ssembly procedure:
Install the neutral start switch and
fix it on the case with the
connecting nut;
Tightening torque: 40Nm
Connect the neutral start switch’s
wiring harness;
’s negative
4.
A
1.
2.
3. Connect the battery
terminal.
48
CHERY AUTOMOBILE CO., LTD Automatic Transmission Fault Diagnosis Manual
T
49
he control mechanism’s
ectromagnectic interlock
isassembly procedure:
Remove the battery’s
negative terminal;
Remove the central control
panel;
Remove the electromagnetic
interlock.
ssembly procedure:
Install the electromagnetic
interlock and fix it with a
bolt;
Tightening torque: 8Nm
Connect the electromagnetic
interlock’s electric terminal;
battery’s
Oil feed pipe
isassembly procedure:
Remove the battery;
2. L
ug to
.
el
D
1.
2.
3. Remove the electromagnetic
interlock’s electric terminal;
4.
A
1.
2.
3. Install the central control
panel;
4.
Connect the
negative terminal.
D
1.
ift the vehicle;
pl
3. Loosen the oil drain
drain the oil;
4. Loosen the fixing bolt on upper
part of the oil feed pipe
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст