Chery SQR 7160 sedan. Manual — part 6
11. FAULT W/O CODE DIAGNOSTIC CHART
1
Ignition On (Engine off), ABS warning light is not on
Possible causes
[Note]
ABS warning light not on maybe caused by open warning light voltage
circuit, burned bulb or damaged warning light control unit.
● blown fuse
● burned ABS warning light blub
● open voltage circuit
●damaged ABS warning light control
unit.
Check ABS warning light fuse at
central electrical box.
OKAY
No okey
Replace fuse.
Check central electrical box fuse socket.
Not okey
OKAY
Replace fuse socket
Remove ABS ECU connector
Ignition: ON position
Is warning light on?
YES
NO
Check if ABS
warning light burned?
YES
NO
Replace
Check if wire connecting ABS
warning light control unit and ECU
short to ground?
YES
Replace electrical harness
Check if there is open circuit in
ABS electrical harness voltage
and ground circuit?
Normal
Not normal
Replace wiring harness
Check ABS warning light voltage
and ground circuit connector.
Not normal
Normal
Repair connector
NO
Go to
INTERMITTENT
FAULT DIAGNOSTIC
Does fault appear again?
YES
Replace ABS warning
light control unit
17
2
Engine, ABS warning light does not go off
Possible causes
[Note]
Possible causes:
defective ABS warning light control unit or open ABS warning light ciucuit.
●defective warning light control unit
●open ABS warning light control unit.
● defective ABS ECU.
Note:
This code only applies to a condition under which there is communication between system and scan tool (ABS voltage
supply is ok) and no code set.
Check if there is open wire between
ECU and ABS warning light control
unit.
YES
Replace wiring harness.
NO
Replace
Not normal
OKAY
Check ABS warning light control unit.
Replace ABS ECU
18
3
Abnormal ABS Opearation
Possible Causes:
[Note]This problem has a close relation with driving and road surface
condition, and it is hard to diagnose. If no code set, perform following check:
●Sensor not correctly installed
●Sensor wiring harness has problem
●damaged sensor
●damaged gear ring
●foreign material on sensor
●damaged wheel bearing
● damaged ABS HCU (hydraulic
unit)
● damaged ABS ECU (electronic
controlled unit)
19
NO
Sensor installed correctly?
Reinstall sensor.
YES
Check sensor output voltage
Not normal
Check each sensor
Replace
Normal
Normal
Not normal
Repair or replace
Normal
Check ABS ECU socket and
central connector
Not normal
Normal
NO
Go to INTERMITTENT
FAULT DIAGNOSIS
YES
Repair wiring harness
or connector
No normal
Replace ABS ECU
YES
Remove ABS ECU.
Check if resistance between
following terminals is within
1.0~1.3 KOhm?
LF: 1-2
RF: 19-20
LR: 5-6
RR: 22-23
Wiggling sensor wiring harness
and connector while measuring.
Does fault appear again?
Repair connector
Check wheel bearing gap
Replace
Not normal
Check each sensor gear ring
Not normal
Normal
Perform HCU DIAGNOSTIC
using scan tool
Not normal
Replace ABS ECU
20
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст