Chery SQR 7160 sedan. Manual — part 55
The manual of 4HP14 A/T removing and installing CHERY AUTOMOBILE CO., LTD
Name Tool
Torque
(Nm)
Hex bolt (lug)
SW=13mm
23
Locking bolt M14 (housing)
SW=6mm
40
Locking bolt M10 (housing)
SW=5mm
15
Back light switch (housing)
SW=27mm
40
Mounting bolt (bearing)
Torx bix 45
20
Mounting bolt (pawl spring)
Torx bix 27
10
Mounting bolt
(Shift gear mechanism)
Torx bix 27
10
Groove nut (output gear)
SW=36mm
50
Mounting bolt (governor)
Torx bix 27
10
Connecting bolt (side cover and
transmission case)
Torx bix 27
10
Mounting bolt (oil pump body)
Torx bix 27
10
Connecting bolt (central seat and
transmission case)
Torx bix 27
10
Locking bolt (converter housing)
SW=5mm 15
Hex bolt(converter housing and
transmission housing)
SW=13mm 23
Mounting bolt (sensing rotor of
sensing rotor)
SW=11mm 10
Connecting bolt (speedometer
drive gear housing)
SW=13mm 23
Connecting bolt (control valve)
Torx bix 27
8
Connecting bolt (oil pan)
Torx bix 27
10
Drain plug (oil pan)
SW=30mm
(Turn to 20 Nm, after being
installed to vehicle, turn further to
100 Nm.)
-30-
The manual of 4HP14 A/T removing & installing CHERY AUTOMOBILE CO., LTD
1.6、Transmission general check
The following points must be checked:
Correct oil level
Checking fluid level when engine idle.
Checking fluid level after fluid temperature rises to 80ºC.
Fluid level must be between Max. and Min. mark.
Low fluid level
Engine running, but no power transferred to transmission, pump does not transfer power.
Abnormal sound from transmission when turning.
High fluid level
Air bubble occurs in transmission, causing power consumption. High fluid temperature when operating in high
speed. Oil evaporates into atmosphere.
Proper engine adjustment
Seeking proper idle speed from whole vehicle manufacturer.
Power transmission (forward and reverse)
It is required to properly adjust the power transmission mechanism.
Stalling speed
Stalling speed range:2100±150rpm
Shifting point
No early or late shifting.
Shifting quality
Adjust
throttle cable
Correct adjustment to accelerating unit is required.
Noise
Noise detection
-31-
The manual of 4HP14 A/T removing and installing CHERY AUTOMOBILE CO., LTD
2、A/T internal disassembling
2.1、Assembly removing
Support transmission assembly with 5 x 46 000
244 braket and drain oil.
Remove converter carrier.
Remove torque converter with special tool 5 x 56
000 090.
NOTE: when removing torque converter, prevent
oil leaking as possible and do not damage oil
pump bushing and sealing ring lip.
Loosen oil pan mounting bolt.
Tool: Using 27# inner socket spanner, remove oil
pan and gasket.
-32-
The manual of 4HP14 A/T removing & installing CHERY AUTOMOBILE CO., LTD
Remove 10 valve plate mounting bolts with
10 big size bolt head.
Tool: 27# quincunx socket spanner.
Turn over transmission by 90 degree, remove
17 mounting bolts on the converter housing.
Tool: 13# socket spanner
Remove converter housing.
NOTE: Speedmeter drive gear may drop off.
Remove the gasket
-33-
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст