Subaru BRZ (2012 year). Manual — part 10

NT-17

Note

NOTE

16.SPEEDOMETER TEST

1) Set the vehicle on speedometer tester.
CAUTION:

Fix the vehicle using a pulling metal (chain or

wire) to the front and rear towing hooks or tie-

down hook to prevent the lateral runout of the

rear wheels and sudden jumping out of the ve-

hicle.

2) Conduct the speedometer test work.
CAUTION:

Do not operate the clutch quickly and do not ac-

celerate or decelerate suddenly during work.

17.BRAKE TEST

1) Keep the front or rear wheels on the ground dur-

ing measurement.

2) When the brake dragging force is large.

• Check the dragging of brake pad or brake shoe.
Specifications:

18.ON THE CAR WHEEL BALANCING

CAUTION:

• Carry out the procedures after measuring the

balance of each single tire.

• Set the vehicle so that the front and rear

wheels are the same height.

• Release the parking brake during measure-

ment.

• Rotate each wheel by hands, and make sure it

rotates without dragging.

• Do not operate the clutch quickly and do not

accelerate or decelerate suddenly during work.

• When an error is indicated during engine

drive, do not use the motor drive together.

1) Set the rigid rack to the specified locations of

side sill, jack up the front or rear two wheels of non-

measuring side and set the pickup stands to two

wheels of measuring side.

2) For drive wheel, drive the tires with engine for

measurement.

3) For non-drive wheel, drive the tires from the on

the car wheel balancer for measurement.

(A) Brake tester
(B) Position for measuring front wheel

(C) Position for measuring rear wheel

NT-00458

(C)

(A)

(B)

NT-00029

Braking force

Rear wheel total

10% or more of load on front or rear
wheels

Difference between
right and left
wheels

8% or less of load on front or rear
wheels

Grand total

50% or more of vehicle weight at the
time of test

(A) Balancer body
(B) Pickup stand (left and right)

NT-00374

(A)

(B)

NT-18

Note

NOTE

IDENTIFICATION

ID

Page

1.

Identification . . . . . . . . . . . . . . . . . . . . . . . ...2

ID-2

Identification

IDENTIFICATION

1. Identification

A: IDENTIFICATION

1. IDENTIFICATION NUMBER & LABEL LOCATIONS

The V.I.N. (Vehicle Identification Numbers) is used to classify the vehicle.

•

POSITIONING OF THE LABEL FOR IDENTIFICATION

(1)

Vehicle identification number
(V.I.N.) (below the driver’s floor
carpet)

(3)

Tire inflation pressure label

(5)

Vehicle identification number
(V.I.N. plate)

(2)

Emission control label

(4)

MVSS label

(6)

Model number label

ID-00399

(1)

(3)

(2)

(4)

(6)

(5)