Jaguar X-Type Sedan and Estate (Wagon). Manual — part 541
The DAB system uses the antenna in the roof pod antenna module and also the rear window heater elements for DAB reception. The
antenna module receives L band signals which are passed directly to the DAB module in the luggage compartment. The rear window
elements receive band 3 signals. The band 3 signals received by the rear window elements are passed through a DAB antenna amplifier
before being passed to the DAB module located in the luggage compartment. The DAB antenna amplifier is located on the
RH (right-hand)
'C' pillar adjacent to the rear window. The amplifier is connected to the rear screen elements by a connector which attaches to the
uppermost press stud on the
RH
of the rear screen
The AM/FM signals are received by elements in the rear window. The AM signals are received by elements located mainly in the upper
LH
(left-hand)
side of the rear window. The FM signals are received by elements across the whole of the rear window. The received signals are
passed through an AM/FM antenna amplifier before being passed to the audio unit. The AM/FM antenna amplifier is located on the
LH
'C'
pillar adjacent to the rear window. The amplifier is connected to the rear screen elements by a connector which attaches to press studs on
the rear screen elements. The rear window elements also incorporate reception for TV signals where a TV system is fitted.
ANTENNA - WAGON
Item
Part Number
Description
1
-
Roof pod antenna module (vehicles from 2009MY)
2
-
Antenna assembly (vehicles up to 2009MY)
3
-
AM/FM antenna
4
-
Television (TV) antenna
5
-
AM/FM antenna amplifier
6
-
DAB/VICS antenna amplifier
7
-
DAB/VICS (Japan only) antenna
Wagon - Vehicles up to 2009MY
The antenna assembly is mounted at the rear of the roof panel, and incorporates the AM, FM and Cellular Phone functions.
The antenna is available in two versions:
AM, FM and Cellular Phone.
AM and FM only.
All vehicles with the pre-installed cellular phone wiring are fitted with the AM/FM and cellular phone antenna as standard.
Access to the antenna assembly fixing nut can only be gained by lowering the headliner.
Wagon - Vehicles from 2009MY
Vehicles from 2009MY are fitted with a roof pod antenna module. The module is secured to the vehicle roof panel with 2 lock nuts and
washers screwed onto captive studs in the module. The module can contain the following antennae dependant on the vehicle equipment
specification:
DAB antenna only
GPS
antenna only
DAB and
GPS
antennae.
• NOTE: On vehicles not fitted with DAB or
GPS
an empty module is fitted.
The DAB system uses the antenna in the roof pod antenna module and also elements in the
LH
rear side window for DAB reception. The
antenna module receives L band signals which are passed directly to the DAB module in the luggage compartment. The side window
elements receive band 3 signals. The band 3 signals received by the side window elements are passed through a DAB antenna amplifier
before being passed to the DAB module located in the luggage compartment. The DAB antenna amplifier is located on the body above the
side window. The amplifier is connected to the elements by a connector which attaches to the center press stud on the
LH
side window
elements. The
LH
side window also incorporates elements for the TV system if fitted.
The AM/FM signals are received by elements in the
RH
rear side window. The AM/FM signals are received by the elements located centrally
in the side window. The received signals are passed through an AM/FM antenna amplifier before being passed to the audio unit. The AM/FM
antenna amplifier is located on the body above the side window. The amplifier is connected to the elements by a connector which attaches
to press studs on the side window elements. The
RH
side window also incorporates elements for the TV system if fitted.
Published: 11-May-2011
Antenna - Antenna
Diagnosis and Testing
Inspection and Verification
1. Verify the customer concern.
1.
2. Visually inspect for obvious signs of electrical damage.
2.
Visual Inspection Chart
Electrical
Module
FM anntena
AM antenna
W iring harness for damage or corrosion
Electrical connector(s)
3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next
step.
3.
4. If the cause is not visually evident, verify the symptom and refer to the Jaguar Approved Diagnostic System.
4.
Published: 11-May-2011
Antenna - AntennaWagon
Removal and Installation
Removal
1. Remove the overhead console.
For additional information, refer to:
Overhead Console
(501-12
Instrument Panel and Console, Removal and Installation).
2. Remove the both sun visors.
For additional information, refer to:
Sun Visor
(501-05 Interior Trim and
Ornamentation, Removal and Installation).
3. Remove the sun visor retaining clips.
4. NOTE: Right-hand shown, left-hand similar.
Detach the front door opening weatherstrip.
5. Remove both A-pillar trim panels.
For additional information, refer to:
A-Pillar Trim Panel
(501-05 Interior
Trim and Ornamentation, Removal and Installation).
6. NOTE: Right-hand shown, left-hand similar.
Detach the B-pillar upper trim panel.
7. NOTE: Right-hand shown, left-hand similar.
Detach the B-pillar lower trim panel.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст