Jaguar X-Type Sedan and Estate (Wagon). Manual — part 155
Published: 11-May-2011
Engine - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27 - Valve Cover RH
In-vehicle Repair
Removal
1. Remove the ignition coils. For additional information, refer toSection
303-07A Engine Ignition
Section
303-07B Glow Plug System
.
2. Detach the wiring harness.
3. Disconnect the variable camshaft timing (VCT) solenoid electrical
connector.
4. Remove the engine cover retaining bracket.
5. Remove the intake manifold support bracket.
6. Remove the valve cover.
Remove and discard the valve cover gaskets.
Installation
1. NOTE: Apply a 5 mm diameter bead of silicone gasket sealant
WSE-M4G323-A6 or equivalent meeting Jaguar specification on the half
round gaskets and apply an 8 mm diameter bead of silicone gasket
sealant on the two places where the cylinder head and front timing cover
join.
• NOTE: Make sure that the valve cover isolator mounts are correctly
installed to the new valve cover gaskets.
To install, reverse the removal procedure.
Install the new valve cover gaskets.
Complete the tightening sequence.
Tighten to 10 Nm.
2. Tighten to 6 Nm.
3. Tighten to 6 Nm.
Published: 11-May-2011
Engine - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27 - EngineVehicles
With: 5-Speed Manual Transmission - MT75/6-Speed Manual Transaxle - MMT6
Removal
Special Tool(s)
Powertrain Assembly Jack
HTJ1200-2
5 Point Security Torx Bit
418-535
Ball joint splitter
204-192
W heel hub puller
205-491
Adaptor nuts
205-491-01
Forcing screw
204-269
Slide hammer
100-012
Slide hammer shaft
100-012-02
Halfshaft remover fork
204-226
Right-hand halfshaft splitter
307-442
Right-hand halfshaft splitter handle
307-443
Pinion oil seal remover
308-208
Link shaft limiting tool
307-446
Engine lifting kit
303-707
Removal
All vehicles
1. NOTE: Left-hand shown, right-hand similar.
Loosen the front hub retaining nuts.
2. Drain the transaxle.
For additional information, refer to:
Transaxle Draining and Filling -
Vehicles W ith: 6-Speed Manual Transaxle - MMT6
(308-03 Manual
Transmission/Transaxle, General Procedures).
3. Remove the steering column lower retaining bolt.
4. Remove the battery tray.
For additional information, refer to:
Battery Tray
(414-01 Battery,
Mounting and Cables, Removal and Installation).
5. Recover the air conditioning (A/C) refrigerant.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст