Jaguar X-Type Sedan and Estate (Wagon). Manual — part 82
19. NOTE: Vehicles with 2.5L or 3.0L engine only.
Attach the engine wiring harness.
Tighten to 10 Nm.
20. Bleed the hydraulic clutch system.
For additional information, refer to:
Clutch System Bleeding - Vehicles
W ith: 6-Speed Manual Transaxle - MMT6
(308-00 Manual
Transmission/Transaxle and Clutch - General Information, General
Procedures).
21.
CAUTION: If brake fluid is spilt on the paintwork, the affected
area must be immediately washed down with cold water.
• NOTE: Make sure the filler cap does not become contaminated.
Install the brake fluid reservoir filler cap.
Published: 11-May-2011
Hydraulic Brake Actuation - Brake Pedal Cross-Shaft
Removal and Installation
Special Tool(s)
Disconnect tool, fuel line.
310-076
Disconnect tool, fuel line.
310-D005
Disconnect tool, fuel line.
412-038
5 Point Security Torx Bit.
418-535
Removal
All vehicles
1. Disconnect the battery ground cable.
For additional information, refer to:
Battery Disconnect and Connect
(414-01 Battery, Mounting and Cables, General Procedures).
2. Recover the air conditioning (A/C) refrigerant.
For additional information, refer to:
Air Conditioning (A/C) System
Recovery, Evacuation and Charging
(412-00 Climate Control System -
General Information, General Procedures).
Vehicles with diesel particulate filter
3. Remove the air cleaner outlet pipe.
For additional information, refer to:
Air Cleaner Outlet Pipe
(303-12B
Intake Air Distribution and Filtering - 2.0L Duratorq-TDCi/2.2L
Duratorq-TDCi (110kW /150PS) - Puma, Removal and Installation).
4. NOTE: Note the orientation of the retaining clip.
Detach the diesel particulate filter (DPF) high-pressure and low-pressure
hoses.
5. Detach the wiring harness.
6. Detach the DPF differential pressure sensor retaining bracket.
Remove the retaining nuts.
7. Disconnect the DPF differential pressure sensor electrical connector.
8. NOTE: Note the orientation of the DPF differential pressure
high-pressure and low-pressure hoses and make sure they are installed in
the same position.
Disconnect the DPF differential pressure sensor high-pressure and
low-pressure hoses.
All vehicles
9. Remove the brake booster.
For additional information, refer to:
Brake Booster - RHD AWD/RHD FWD
(206-07 Power Brake Actuation, Removal and Installation).
All except vehicles with diesel engine
10. Disconnect the upper fuel vapor hose from the evaporative emission
canister purge valve.
11. Detach the oxygen sensor electrical connectors.
12. Disconnect the evaporator solenoid electrical connector.
13. Disconnect the lower fuel vapor hose from the evaporative emission
canister purge valve.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст