Jaguar X-Type Sedan and Estate (Wagon). Manual — part 646
1. To install, reverse the removal procedure.
Published: 11-May-2011
Instrument Panel and Console - Overhead Console
Removal and Installation
Removal
1. Detach the roof console.
2. Remove the roof console.
Disconnect the electrical connector(s).
Installation
1. To install, reverse the removal procedure.
Published: 11-May-2011
Instrument Panel and Console - Overhead Console Switch Moulding
Removal and Installation
Removal
• NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
1. Remove the overhead console.
For additional information, refer to:
Overhead Console
(501-12
Instrument Panel and Console, Removal and Installation).
2. NOTE: W here installed.
Remove the front intrusion sensor.
3. NOTE: W here installed.
Remove the garage door opener module.
4.
CAUTION: Make sure that only the head of the fixing is removed.
Do not drill any deeper than necessary. Failure to follow this instruction
may result in damage to the component.
Remove the printed circuit board (PCB) cover.
Using a 5mm drill bit, carefully drill out and remove the 4 plastic
fixing heads.
5. Remove the PCB.
6. Remove the two switch mouldings.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст