Jaguar XJ (X350). Manual — part 1540

-> No
REPAIR as necessary. TEST the system for normal operation.

PINPOINT TEST G189148p3 : THE
ROOF OPENING PANEL IS NOISY
DURING OPERATION

G189148t6 : CHECK THE OPERATION OF THE ROOF
OPENING PANEL GLASS

1. Cycle the roof opening glass from the fully open to the fully closed position.

•

Is the roof opening panel glass loose?

-> Yes
ADJUST the roof opening glass.
TEST the system for normal operation.

-> No
GO to Pinpoint Test G189148t7.

G189148t7 : CHECK FOR OBSTRUCTIONS

1. Check the roof opening panel frame for foreign material, damage or looseness.

•

Is the roof opening panel obstructed or damaged?

-> Yes
REMOVE the obstruction. If necessary, INSTALL a new roof opening panel track and rail
assembly.
TEST the system for normal operation.

-> No
GO to Pinpoint Test G189148t8.

G189148t8 : CHECK THE ROOF OPENING PANEL
MOTOR

1. Cycle the roof opening panel glass from the fully open to the fully closed position.

•

Does the roof opening panel motor make excessive noise?

-> Yes
CHECK the roof opening panel motor for correct mounting. If necessary, INSTALL a new
roof opening panel motor.
TEST the system for normal operation.

-> No

ADJUST the roof opening panel glass as necessary. TEST the system for normal operation.

PINPOINT TEST G189148p4 : THE
ROOF OPENING PANEL DOES NOT
STOP FLUSH FROM ANY POSITION

G189148t9 : CHECK THE ROOF OPENING PANEL
ALIGNMENT

1. Check the roof opening panel alignment.

•

Is the roof opening glass adjusted correctly?

-> Yes
GO to Pinpoint Test G189148t10.


-> No
ADJUST the roof opening glass as necessary. TEST the system for normal operation.

G189148t10 : CHECK THE ROOF OPENING PANEL
WEATHERSTRIP

1. Inspect the roof opening panel weatherstrip for looseness, damage and correct installation.

•

Is the roof opening panel weatherstrip OK and installed correctly?

-> Yes
GO to Pinpoint Test G189148t11.


-> No
REPAIR or INSTALL a new roof opening panel weatherstrip as necessary.
TEST the system for normal operation.

www.

G189148t11 : CHECK FOR OBSTRUCTION IN THE
ROOF OPENING PANEL

1. Inspect the roof opening panel assembly for obstructions in the frame.

•

Are any obstructions found?

-> Yes
REMOVE the obstruction. If necessary, INSTALL a new roof opening panel frame.
TEST the system for normal operation.

-> No
INSTALL a new roof opening panel control module.
TEST the system for normal operation.

Removal and installation

Air Deflector (76.82.07)

Removal

1 . Reposition the roof opening glass fully rearward.

2 . NOTE:

Right-hand shown, left-hand similar.

Remove the air deflector retaining screws.

3 . Remove the air deflector.

Installation

1
.

CAUTION: Do not over tighten the air deflector retaining screws when

installing.

To install, reverse the removal procedure.

www.