Jaguar XJ (X350). Manual — part 1058

31 . Connect the battery ground cable.

For additional information, refer to Battery Connect (86.15.15)

32 . Carry out a transmission fluid level check.

For additional information, refer to Transmission Fluid Level Check

In vehicle repair

Extension Housing Seal (44.20.18)

Special Service Tools

Crankshaft Damper Remover

303-D121

Output Shaft Flange Holding Tool

205-053

Pinion Seal Replacer

204-264

Powertrain Assembly Jack

HTJ1200-2

www.

Seal Remover Input and Output

308-375

Slide Hammer

100-012

Slide Hammer Adaptor

100-012-01

Socket Output Flange Remover/Installer

205-789

Removal

Vehicles with diesel engine

1 . Remove the air deflector.

For additional information, refer to Air Deflector (76.11.41)

2 . Remove the diesel particulate filter.

For additional information, refer to Diesel Particulate Filter (DPF)

All vehicles

3

.

CAUTION: Under no circumstances must the flexible coupling (or its fixings) be

loosened or removed from the driveshaft. Failure to follow this instruction may result in

damage to the vehicle.

CAUTION: Make sure the front of the driveshaft does not put an excessive load on

the center bearing. Failure to follow this instruction may result in damage to the vehicle.

Detach the driveshaft from the transmission flange.

Mark the position of the driveshaft in relation to the transmission flange.

Mark the position of each nut and bolt in relation to the transmission

flexible joint.

4 . Loosen the heat shield retaining nut.

5 . Install suitable cord to the heat shield retaining nut stud.

Tighten the retaining nut.

www.