Jaguar XJ (X350). Manual — part 962
Crankshaft Position (CKP) Sensor
(18.30.12)
Removal
1 . Remove the air deflector. <<501-02>>
2 . Disconnect the crankshaft position (CKP) sensor electrical connector.
3 . Remove the CKP sensor.
Installation
1 . To install, reverse removal procedure.
Tighten to 7 Nm.
www.
Engine Control Module (ECM) (18.30.01)
Special Service Tools
5 Point Security Torx Bit
418-535
Removal
1 . Disconnect the battery ground cable. <<414-01>>
2 . Remove the cowl vent screen. <<501-02>>
3 . Remove the cabin air filter.
1) Detach the cabin air filter.
2) Remove the cabin air filter.
4 . Remove the cabin air filter housing.
5 . Remove the engine compartment panel.
1) Remove the engine compartment panel retaining bolt.
2) Remove the engine compartment panel.
6
.
NOTE:
The engine control module (ECM) electrical connector retaining bolt remains captive in
the electrical connector.
Using the special tool, loosen the ECM electrical connector retaining bolt.
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст