Jaguar XJ (X350). Manual — part 811
Symptom chart (vehicles without supercharger)
Symptom
Possible cause
Action
Vehicle does not
start/hard starting/poor
performance
Restricted/blocked air intake
Restricted/blocked air cleaner
element
Clear the restriction,
Air Cleaner (19.10.05) Replace the
air cleaner element as necessary,
Air Cleaner Element (19.10.08)
Excessive intake noise
Intake pipe
disconnected/damaged after
the air cleaner
Air cleaner assembly incorrectly
assembled/damaged
Check the intake system and hoses
for correct installation/damage,
Air Cleaner (19.10.05)
Symptom
Possible cause
Action
Lack of
boost
Supercharger drive
belt
broken/slipping
Supercharger fault
supercharger air
intake elbow
fault
Major air leakage
(after the
supercharger)
Check the supercharger and drive belt (see visual inspection).
For supercharger air intake elbow tests, GO to Pinpoint Test
G532443p1.
Check the charge air coolers and pipework (see visual
inspection).
Noise
Supercharger drive
belt slipping
Supercharger fault
Major air leakage
(after the
supercharger)
Check the supercharger and drive belt (see visual inspection).
Remove the supercharger drive belt and recheck for noise. Turn
the supercharger by hand and check for excessive resistance.
Check the supercharger pulley for excessive play. Check the
charge air coolers and pipework (see visual inspection).
DTC index
NOTE:
Generic scan tools may not read the codes listed, or may read only 5-digit codes. Match the 5
digits from the scan tool to the first 5 digits of the 7-digit code listed to identify the fault (the last
2 digits give extra information read by the manufacturer-approved diagnostic system).
NOTE:
For a full list of DTCs.
Electronic Engine Controls - VIN Range: G45704->G99999
DTC
Description
Possible causes
Action
P010100
MAF circuit
range/performance
Blocked air cleaner
Air intake leak
Engine breather leak
MAF sensor to ECM
sensing circuit:
high resistance,
intermittent
short circuit to
ground
MAF sensor supply
circuit: high
resistance
Clear the restriction,
Air Cleaner (19.10.05) Replace the air
cleaner element as necessary,
Air Cleaner Element (19.10.08) Inspect
the engine breather system,
For MAF sensor tests,
Electronic Engine Controls - VIN Range:
G45704->G99999
P010600
MAP/Barometric
pressure circuit
range/performance
Intake manifold air
leak (loose or
missing
component)
MAP sensor to ECM
circuit(s) fault
MAP sensor failure
Check the intake system and hoses for
correct installation/damage,
Air Cleaner (19.10.05) Replace the air
cleaner element as necessary,
Air Cleaner Element (19.10.08) Check
the intake manifold for correct
installation/damage,
Intake Manifold - VIN Range: G45704-
>G99999 (30.15.01) For MAP sensor
tests,
Electronic Engine Controls - VIN Range:
G45704->G99999 .
P017100
System too lean (right
hand bank)
Air intake leak
between MAF
sensor and
cylinder head
Fuel filter/system
restriction
MAF sensor fault
Check the intake system and hoses for
correct installation/damage,
Air Cleaner (19.10.05) Check the fuel
pressure, check the fuel lines,
Fuel Tank and Lines - 4.2L NA V8 -
AJV8/4.2L SC V8 - AJV8/3.0L NA V6 -
AJ27/3.5L NA V8 - AJV8, VIN Range:
G45704->G99999 Check the exhaust
www.
(low intake air
flow)
Exhaust leak (before
catalyst)
system (before catalyst) for condition
and security,
P017200
System too rich (right
hand bank)
Restricted air filter
MAF sensor fault
(high intake air
flow)
Clear the restriction,
Air Cleaner (19.10.05) Replace the air
cleaner element as necessary,
Air Cleaner Element (19.10.08) For MAF
sensor tests,
Electronic Engine Controls - VIN Range:
G45704->G99999 .
P017400
System too lean (left
hand bank)
Air intake leak
between MAF
sensor and
cylinder head
Fuel filter/system
restriction
MAF sensor fault
(low intake air
flow)
Exhaust leak (before
catalyst)
Check the intake system and hoses for
correct installation/damage,
Air Cleaner (19.10.05) Check the fuel
pressure, check the fuel lines,
Fuel Tank and Lines - 4.2L NA V8 -
AJV8/4.2L SC V8 - AJV8/3.0L NA V6 -
AJ27/3.5L NA V8 - AJV8, VIN Range:
G45704->G99999 Check the exhaust
system (before catalyst) for condition
and security,
P017500
System too rich (left
hand bank)
Restricted air filter
MAF sensor fault
(high intake air
flow)
Clear the restriction,
Air Cleaner (19.10.05) Replace the air
cleaner element as necessary,
Air Cleaner Element (19.10.08) For MAF
sensor tests,
Electronic Engine Controls - VIN Range:
G45704->G99999 .
P050600
Idle air control system
RPM lower than
expected
Restricted air cleaner
element
MAF sensor fault
(high intake air
flow)
Clear the restriction,
Air Cleaner (19.10.05) Replace the air
cleaner element as necessary,
Air Cleaner Element (19.10.08) For MAF
sensor tests,
Electronic Engine Controls - VIN Range:
G45704->G99999 .
P050700
Idle air control system
RPM higher than
expected
Intake air leak
between MAF
sensor and
Check the intake system and hoses for
correct installation/damage,
Air Cleaner (19.10.05) Inspect the
throttle
Intake air leak
between throttle
and engine
Engine crankcase
breather leak
engine breather system,
Pinpoint tests
NOTE:
Check and rectify basic faults before beginning diagnostic routines involving pinpoint tests.
PINPOINT TEST G532443p1 : CHECK
THE SUPERCHARGER AIR INTAKE
ELBOW
G532443t1 : CHECK THE AIR INTAKE ELBOW VACUUM LINE
1. Check the vacuum connection to the supercharger air intake elbow at both ends. 2. Check the
vacuum line to the supercharger air intake elbow along its length.
Is the vacuum line connected and in good condition?
-> Yes
GO to Pinpoint Test G532443t2.
-> No
CONNECT or replace the vacuum line as necessary. Test the system for normal operation.
G532443t2 : CHECK THE OPERATION OF THE AIR INTAKE ELBOW
ACTUATOR LINKAGE
1. Disconnect the vacuum line from the actuator diaphragm. 2. Connect a suitable hand vacuum
pump to the actuator diaphragm. 3. Apply a vacuum to the actuator diaphragm. 4. Observe the
actuator linkage operation.
Does the actuator linkage operate?
-> Yes
GO to Pinpoint Test G532443t3.
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст