Jaguar XJ (X350). Manual — part 632
Fuel Injectors (18.10.02)
Removal
1 . Remove the fuel charging wiring harness.
For additional information, refer to
2 . Remove the fuel injectors.
Remove the fuel injector locating clips.
3 . Remove and discard the O-ring seals.
Installation
1 . NOTE:
Install new fuel injector O-ring seals.
To install, reverse the removal procedure.
Lubricate the fuel injector O-ring seals with clean engine oil.
www.
Fuel Injection Supply Manifold (19.60.13)
Removal
1 . Remove the fuel injectors.
For additional information, refer to Fuel Injectors (18.10.02)
2 . Remove the fuel pressure sensor.
Remove and discard the O-ring seals.
Installation
1 . NOTE:
Install new O-ring seals.
To install, reverse the removal procedure.
Tighten to 10 Nm.
Throttle Body - VIN Range: G00442-
>G45703 (19.70.04)
Removal
1
.
WARNING: When relieving cooling system pressure, cover the expansion tank cap
with a thick cloth to prevent the possibility of scalding. Failure to follow these instructions
may result in personal injury.
Remove the expansion tank cap to relieve the cooling system pressure.
2
.
CAUTION: Do not attempt to clean the throttle body. The bore and the throttle
plate has a special coating applied during manufacture which should not be removed.
Remove the air cleaner outlet tube. <<303-12A>>
3 . Disconnect the throttle motor electrical connector.
4 . Disconnect the throttle position (TP) sensor electrical connector.
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст