Jaguar XJ (X350). Manual — part 229

Diagnosis and testing

Hydraulic Brake Actuation

For additional information, refer to

<<206-00>>

.

Removal and installation

Brake Fluid Reservoir (70.30.16)

Removal

1

.

CAUTION: If brake fluid comes into contact with the paintwork, the affected area

must be immediately washed down with cold water.

NOTE:

Make sure the brake fluid reservoir filler cap does not become contaminated.

Remove the brake fluid reservoir filler cap.

2 . Disconnect the brake fluid level sensor electrical connector.

3 . Using a suitable suction device drain the brake fluid reservoir.

www.

4 . NOTE:

Remove and discard the O-ring seals.

Remove the brake fluid reservoir from the master cylinder.

Installation

1 . NOTE:

Install new O-ring seals.

To install, reverse the removal procedure.

2 . Tighten to 8 Nm.

3 . After installation, bleed the brake system.

<<206-00>>

www.