Jaguar XJ (X350). Manual — part 209
G531320t23 : CHECK IF THE SHORT CIRCUIT IS IN THE HARNESS OR THE
SWITCH
1.
Electric parking brake switch (TL82) connector disconnected. 2. Measure the resistance between:
CR32 connector, harness side
Vehicle battery
Electric parking brake switch apply 2 - signal - Pin 02 Negative terminal
•
Is the resistance greater than 100 Kohms?
-> Yes
INSTALL a new EPB switch.
Parking Brake Switch (70.35.46)
-> No
REPAIR the short circuit. For additional information, refer to the wiring diagrams.
PINPOINT TEST G531320p7 :
SECONDARY APPLY HARNESS SHORT
CIRCUIT TO BATTERY OR OPEN
CIRCUIT
G531320t31 : CHECK THE PRIMARY APPLY SIGNAL CIRCUIT FOR SHORT
CIRCUIT TO POWER
1. Key off. 2.
Electric parking brake module connector 1 (CR50) disconnected. 3.
Electric parking brake module connector 2 (CR32) disconnected. 4. Key on, engine off. 5. Measure the
resistance between:
CR50 connector, harness side
Vehicle battery
Electric parking brake switch apply 1 - signal - Pin 10 Positive terminal
•
Is the resistance greater than 100 Kohms?
-> Yes
GO to Pinpoint Test
G531320t32
.
-> No
GO to Pinpoint Test
G531320t38
.
G531320t32 : CHECK THE PRIMARY RELEASE SIGNAL CIRCUIT FOR SHORT
CIRCUIT TO POWER
1. Measure the resistance between:
CR50 connector, harness side
Vehicle battery
www.
Electric parking brake switch release 1 - signal - Pin 11 Positive terminal
•
Is the resistance greater than 100 Kohms?
-> Yes
GO to Pinpoint Test
G531320t33
.
-> No
GO to Pinpoint Test
G531320t39
.
G531320t33 : CHECK THE SECONDARY APPLY SIGNAL CIRCUIT FOR SHORT
CIRCUIT TO POWER
1. Measure the resistance between:
CR32 connector, harness side
Vehicle battery
Electric parking brake switch apply 2 - signal - Pin 02 Positive terminal
•
Is the resistance greater than 100 Kohms?
-> Yes
GO to Pinpoint Test
G531320t34
.
-> No
GO to Pinpoint Test
G531320t40
.
G531320t34 : CHECK THE SECONDARY RELEASE SIGNAL CIRCUIT FOR
SHORT CIRCUIT TO POWER
1. Measure the resistance between:
CR32 connector, harness side
Vehicle battery
Electric parking brake switch release 2 - signal - Pin 14 Positive terminal
•
Is the resistance greater than 100 Kohms?
-> Yes
GO to Pinpoint Test
G531320t35
.
-> No
GO to Pinpoint Test
G531320t41
.
G531320t35 : CHECK THE SECONDARY APPLY SIGNAL CIRCUIT FOR OPEN
CIRCUIT
1.
Electric parking brake switch (TL82) connector disconnected. 2. Measure the resistance between:
CR32 connector, harness side
TL82 connector, harness side
Electric parking brake switch apply 2 - signal - Pin
02
Electric parking brake switch apply 2 - signal - Pin
07
•
Is the resistance less than 10 ohms?
-> Yes
GO to Pinpoint Test
G531320t36
.
-> No
REPAIR the open circuit. For additional information, refer to the wiring diagrams.
G531320t36 : CHECK THE SWITCH RETURN SIGNAL CIRCUIT FOR OPEN
CIRCUIT
1. Measure the resistance between:
CR32 connector, harness side
TL82 connector, harness side
Electric parking brake switch - switch return - Pin
06
Electric parking brake switch - switch return - Pin
06
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст