Jaguar XJ (X350). Manual — part 358
20 . Install the engine coolant housing.
•
Install new O-ring seals.
•
Tighten to 25 Nm.
21 . Position the crankshaft.
•
Turn the crankshaft until the key is in the 11 O'clock position.
•
Remove the crankshaft pulley bolt and washer.
22 . Install a new cylinder head gasket (left-hand shown - right-hand similar).
3. Make sure the cylinder head dowels are correctly located.
4. Install a new cylinder head gasket.
23 . NOTE:
Install the bolts in the indicated sequence.
Install the left-hand cylinder head.
•
Tighten to 30 Nm.
•
Tighten 90°.
•
Loosen 360°.
•
Tighten to 30 Nm.
•
Tighten 90°.
•
Tighten 90°.
www.
24 . NOTE:
Install the bolts in the indicated sequence.
Install the right-hand cylinder head.
•
Tighten to 30 Nm.
•
Tighten 90°.
•
Loosen 360°.
•
Tighten to 30 Nm.
•
Tighten 90°.
•
Tighten 90°.
25 . Install the left-hand inlet camshaft.
26
.
CAUTION: Do not install the cylinder head camshaft journal thrust caps until the
camshaft journal caps are installed or damage to the thrust caps may occur.
NOTE:
Lubricate the camshafts and the camshaft bearing caps with oil WSE-M2C908-A or
equivalent meeting Jaguar specification prior to installation.
Install the left-hand inlet camshaft bearing cap bolts evenly.
•
Install the inlet camshaft bearing caps.
•
Tighten to 10 Nm.
27 . Install the left-hand exhaust camshaft.
28
.
CAUTION: Do not install the cylinder head camshaft journal thrust caps until the
camshaft journal caps are installed or damage to the thrust caps may occur.
NOTE:
Lubricate the camshafts and the camshaft bearing caps with oil WSE-M2C908-A or
equivalent meeting Jaguar specification prior to installation.
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст