Jaguar XJ (X350). Manual — part 1483

Diagnosis and testing

Glass, Frames and Mechanisms

Inspection and Verification

1 . Verify the customer concern by operating the system.

2 . Visually inspect for obvious signs of mechanical and electrical damage.

Visual Inspection Chart

Mechanical

Electrical

•

Window glass.

•

Window regulator.

•

Fuse(s).

•

Window motor.

•

Loose or corroded electrical connector(s).

•

Switch.

•

Circuit(s).

1 . If an obvious cause for an observed or reported concern is found, correct the cause (if
possible) before proceeding to the next step.

2 . If the concern is not visually evident, verify the symptom and refer to the Jaguar Approved
Diagnostic System.

Removal and installation

Front Door Window Glass (76.31.01)

Removal

1 . Lower the front door window glass approximately 290 mm (11.4 in).

2 . Detach the front door wiring harness.

3 . Disconnect the electrical connectors.

4 . Detach the front door wiring harness grommet.

5 . Remove the front door inner weathershield.

www.

6 . Remove the front door window glass retaining bolt.

7
.

Detach the front door window glass from the front door window regulator retaining
clip.

8 . Remove the front door window glass.

Installation

1
.

NOTE:

Make sure the front door window glass is correctly located to the front door
window regulator.

To install reverse the removal procedure.

Tighten to 7 Nm.

www.