Jaguar XJ (X350). Manual — part 1151
Installation
WARNING: Place the vehicle in a quarantined area and arrange "No Smoking/Petrol Fumes"
signs about the vehicle.
WARNING: Before any work is carried out on the fuel system, ground the vehicle to earth
and maintain the ground connection until the work is complete.
WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working
on or near any fuel related components. Highly flammable vapors are always present and may
ignite. Failure to follow these instructions may result in personal injury.
WARNING: Do not carry or operate cellular phones when working on or near any fuel
related components. Highly flammable vapors are always present and may ignite. Failure to follow
these instructions may result in personal injury.
WARNING: The fuel system remains pressurized for a long time after the ignition is switched
off. The fuel pressure must be relieved before attempting any repairs. Failure to follow these
instructions may result in personal injury.
WARNING: After carrying out repairs, the fuel system must be checked visually for leaks.
Failure to follow these instructions may result in personal injury.
WARNING: This procedure involves fuel handling. Be prepared for fuel spillage at all times
and always observe fuel handling precautions. Failure to follow these instructions may result in
personal injury.
WARNING: If taken internally do not induce vomiting, seek immediate medical attention.
Failure to follow these instructions may result in personal injury.
WARNING: If fuel contacts the eyes, flush the eyes with cold water or eyewash solution and
seek medical attention.
WARNING: Wash hands thoroughly after handling, as prolonged contact may cause
irritation. Should irritation develop, seek medical attention.
1 . To install, reverse the removal procedure.
Tighten to 35 Nm.
www.
2 . NOTE:
Left-hand shown, right-hand similar
Loosely install the 2 rear subframe front retaining bolts.
Install new retaining bolts.
3 . NOTE:
Left-hand shown, right-hand similar
Loosely install the 6 noise, vibration and harshness brace retaining bolts.
4 . NOTE:
Left-hand shown, right-hand similar
Tighten the 2 bolts to 125 Nm.
5 . NOTE:
Left-hand shown, right-hand similar
Tighten the 6 bolts to 48 Nm.
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст