Jaguar XJ (X350). Manual — part 596
vehicle.
Remove the cooling fan motor and shroud.
Installation
All vehicles
1
.
CAUTION: Make sure that the radiator is not damaged when installing the cooling
fan motor and shroud. Failure to follow this instruction may result in damage to the
vehicle.
CAUTION: Make sure that the retaining lugs of the radiator are not damaged when
installing the cooling fan motor and shroud. Failure to follow this instruction may result in
damage to the vehicle.
To install, reverse the removal procedure.
Tighten to 7 Nm.
Vehicles with 3.5L or 4.2L engine
2 . Tighten to 10 Nm.
All vehicles
3 . Tighten to 9 Nm.
4 . Fill the cooling system.
For additional information, refer to
www.
Radiator (26.40.01)
Removal
All vehicles
1 . Remove the cooling fan motor and shroud.
For additional information, refer to Cooling Fan Motor and Shroud (26.25.25)
2 . Detach the transmission oil cooler inlet and return pipes.
Remove and discard the O-ring seals.
Cap the oil cooler inlet and return pipes and the oil cooler.
3 . Detach the lower coolant hose.
4 . Raise the vehicle.
5 . Remove the radiator lower cowl.
Vehicles with supercharger
6 . Remove the oil cooler.
For additional information, refer to Oil Cooler - Vehicles With: Supercharger (12.60.68)
7 . Disconnect the water pump coolant hoses.
8 . Remove the water pump retaining bolt.
9 . Remove the water pump.
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст