Jaguar XJ (X350). Manual — part 1537
Roof Opening Panel Alignment
1. NOTE:
Left-hand shown, right-hand similar.
Detach the sight shield at the front of the roof and swing inwards towards the rear of vehicle.
2.
CAUTION: Make sure the air deflector is only detached from the roof opening
panel using the 20mm (0.78 inches) area at the end of the air deflector as defined in step
1 of the ilustration and text below. Failure to follow this instruction will result in damage
to the component.
CAUTION: Do not pull on the air deflector rubber pleat. Failure to follow this
instruction will result in damage to the component.
NOTE:
Right-hand shown, left-hand similar.
Detach the air deflector.
•
Detach the rear of the air deflector.
•
Detach the air deflector upper retainer.
•
Swing the front of the air deflector inwards towards the rear of the vehicle.
3. NOTE:
Left-hand shown, right-hand similar.
Loosen the roof opening panel glass retaining screws.
4. Adjust the front edge of the roof opening panel glass to between flush and 1 mm (0.04 in)
low.
5. Adjust the rear glass edge to between flush and 1 mm (0.04 in) low.
6. NOTE:
Left-hand shown, right-hand similar.
Tighten to 4 Nm.
www.
7. NOTE:
Right-hand shown, left-hand similar.
Reposition the air deflector to the roof opening panel runner.
8. NOTE:
Right-hand shown, left-hand similar.
Install the air deflector.
•
Make sure the air deflector is fully seated to the rear retaining clip.
•
Attach the air deflector upper retainer.
9. NOTE:
Left-hand shown, right-hand similar.
Install the sight shields.
Description and operation
Roof Opening Panel
Item Part Number
Description
1
—
Roof opening panel shield
2
—
Roof opening panel glass
3
—
Trough assembly
4
—
Air deflector
5
—
Roof opening panel frame
6
—
Roof opening panel motor
7
—
Roof opening panel control switch
8
—
Roof opening panel weatherstrip
The roof opening panel is available as an option. The roof opening panel control module
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст