Jaguar XJ (X350). Manual — part 1407
General procedures
Hood Alignment (76.16.02)
1. NOTE:
Left-hand shown, right-hand similar.
Remove the hood striker plate.
2. Remove the hood safety latch.
3. NOTE:
Support the hood while the hood struts are remove.
NOTE:
Left-hand shown, right-hand similar.
Remove the hood strut.
4. NOTE:
Left-hand shown, right-hand similar.
Loosen the hood hinge retaining bolts.
5. NOTE:
Left-hand shown, right-hand similar.
Adjust the hood height.
6. NOTE:
Make sure the spacing between the grille to hood, headlamps to hood and fenders to hood
are equal.
Set the hood alignment to 1 mm (0.04 in) lower than nominal at the middle edges of the hood.
7. NOTE:
Left-hand shown, right-hand similar.
Tighten the hood hinge retaining bolts.
www.
•
Tighten to 25 Nm.
8. NOTE:
Left-hand shown, right-hand similar.
Adjust the hood bump stops to obtain the correct profile between the hood and the headlamps.
9. NOTE:
Left-hand shown, right-hand similar.
Install the hood strut.
10. Install the hood safety latch.
•
Tighten to 11 Nm.
11. NOTE:
Left-hand shown, right-hand similar.
Install the hood striker.
•
Tighten to 11 Nm.
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст