Jaguar XJ (X350). Manual — part 1551

Detach the front fender splash shield.

5 . Disconnect the lighting electrical connector.

Vehicles with headlamp washers

6 . Detach the headlamp washer hose from the reservoir.

All vehicles

7 . NOTE:

Right-hand shown, left-hand similar.

Remove the front bumper cover.

Detach the front bumper cover from the retaining clips.

Installation

All vehicles

1 . To install, reverse the removal procedure.

Vehicles with parking aid

2

.

Carry out the following procedure if a new bumper cover or a new parking aid sensor holder

is to be fitted.

WARNING: 3M VHB surface cleaner is highly flammable. Do not smoke or carry lighted

tobacco or open flame of any type. Highly flammable vapors are always present and may ignite.

Failure to follow these instructions may result in personal injury.

WARNING: 3M VHB surface cleaner is harmful. Avoid contact with the eyes. Avoid ingestion

or inhalation. Avoid contact with the skin. If the cleaner contacts the eyes, flush the eyes with cold

water for at least 15 minutes and seek immediate medical attention. If taken internally do not

induce vomiting, seek immediate medical attention. If the vapors are inhaled, remove the person

to fresh air. If the signs/symptoms of inhalation persist, seek medical attention. If the cleaner

contacts the skin, immediately flush the skin with large amounts of water. Remove contaminated

clothing. If the irritation persists seek medical attention. Failure to follow these instructions may

result in personal injury.

www.

.

New parking aid sensor holders should be painted before assembly. Do not paint the

bonding surface.

NOTE:

Wipe in one direction only.

Wipe the bonding surface of the parking aid sensor holder with 3M VHB surface cleaner.

4

.

NOTE:

New bumper covers should be painted before assembly. Do not paint the bonding

surface.

NOTE:

Wipe in one direction only.

NOTE:

Front bumper cover shown, rear similar.

Wipe the area around the front bumper cover holder aperture with 3M VHB surface cleaner.

3 NOTE:

WARNING: 3M adhesive DP8005 is highly flammable. Do not smoke or carry lighted tobacco

or open flame of any type. Highly flammable vapors are always present and may ignite. Failure to

follow these instructions may result in personal injury.

WARNING: 3M adhesive DP8005 is harmful. Avoid contact with the eyes. Avoid ingestion or

inhalation. Avoid contact with the skin. If the adhesive contacts the eyes, flush the eyes with cold

water for at least 15 minutes and seek immediate medical attention. If taken internally do not

induce vomiting, drink two glasses of water and seek immediate medical attention. If the adhesive

vapors are inhaled, remove the person to fresh air. If the signs/symptoms of inhalation persist,

seek medical attention. If the adhesive contacts the skin, immediately flush the skin with large

amounts of water. Remove contaminated clothing. If the irritation persists seek medical attention.

Failure to follow these instructions may result in personal injury.

5

.

CAUTION: 3M adhesive DP8005 must only be applied using a 3M EPX applicator and

an orange 10:1 ratio applicator nozzle.

Make sure the applicator nozzle is correctly aligned on to the EPX applicator.

6

.

CAUTION: 3M adhesive DP8005 has a work life of three minutes. Do not apply the

adhesive to more than one parking aid sensor holder at a time.

NOTE:

Make sure the adhesive is correctly mixed.

www.