Defender (1993+). Manual — part 79
SUSPENSION
PAN HARD ROD RADIUS ARM
Remove
Remove
1.
Remove fixings at mounting arm.
1.
Loosen road wheel retaining nuts.
2.
Remove fixings at axle bracket.
2.
Raise front of vehicle. Support chassis on
3.
Remove Panhard rod.
stands and remove wheel.
4.
Press out flexible bushes. Ensure the steel
3.
Support front axle weight with jack.
tubing locates on the outer edge of the bush
and not on the rubber inner.
4.
Remove radius arm to chassis side member
fixings.
5.
Disconnect track rod at ball joint.
6. Remove fixings, radius arm to axle.
7.
Lower radius arm front end to clear axle and
remove from vehicle.
Refit
5.
Fit
replacement bushes.
CAUTION: Apply pressure to outer edge of bush,
and not rubber inner.
6. Reverse 1
to
4.
Tighten fixings
to
88Nm.
SUSPENSION
8.
Press out flexible bushes.
Refit
9. Press in replacement bushes.
7. Withdraw lower seating washer, rubber bush
and cupwasher.
8.
Remove fixings, shock absorber to mounting
bracket.
9. Withdraw mounting bracket.
10. Lift
off
top seating washer, rubber bush and
CAUTION: When pressing in new bushes press
on outer edge of bush and not rubber inner.
10.
Reverse
1
to
7. Tighten fixings to following
torques:
cupwasher.
Radius arm to chassis 176Nm.
Radius arm to axle 197Nm.
Refit
FRONT SHOCK ABSORBER
11. Reverse instructions 1 to 10.
Remove
1.
Loosen road wheel retaining
nuts.
2.
Support chassis on stands and remove road
wheel.
3. Support axle weight with jack.
4.
Remove shock absorber lower fixing and
withdraw e cupwasher, rubber bush and
seating washer.
5.
Remove four shock absorber bracket fixings.
6.
Withdraw
shock
absorber
and
bracket
complete.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст